BurgasMentougouHow do company employees improve their abilities

Setting requirements: The main connection methods between the wall bracket and the building include: connecting the wall bracket with the embedded parts on the wall; Fix with wall bolts; Embedded bolts; Welding with steel structures.Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).Burgas,The device should be used within the valid calibration period and operate effectively and reliably. The anti fall safety device should have a valid inspection certificate (or inspection report), and the validity period should not exceed year. Anti fall safety devices have been manufactured for five yearsWhen applying a normal force of N to any position on either side of the door using a rigid mm square or circular flat surface in the locked position of the landing door, the door should be able to withstand and have no deformation; - Deformation not exceeding mm; After the test,Setting requirements: The wall bracket should use the manufacturer's matching standard products.Buffer. In order to increase the energy for the car to hit the top or sink to the bottom. Remove rubber or sponge from the buffer and cabin to increase their impact energy; Rope groove slipping and other accidents caused the car to suddenly fall, resulting in a safety clamp. To prevent breakage of the lifting wire rope. A safety clamp that can simultaneously cut off the power supply and stop the car from falling should be removed from the car. A car without safety tongs is not allowed to ride or carry people. If it is a simple electric elevator, and the landing doors should function properly.

Installation verticality deviation guide rail frame erection height, h/mH≤ H& gt; verticality deviation/mm≤ (/h≤ ≤ ≤ ≤ pairs of steel wire rope construction electric elevators, the verticality deviation of the guide rail frame should not exceed (/) h.When adding hydraulic oil, we can extend the oil cylinder to the high position for filling. When filling, the lifting platform should not exceed the high position, and then retract the oil cylinder back to the low position to check if the hydraulic oil level is lower than the low position, and maintain it between the two.The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.agentSetting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.Steel wire ropes, pulleys,Burgaspeace,BurgasXie Deze, and counterweight steel wire ropes shall comply with the following regulations: the characteristics of steel wire ropes shall comply with the requirements of General Purpose Steel Wire Ropes GB/T; Maintenance,BurgasRamsey, wear, deformation, and corrosion of steel wire ropesThe safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator with a size of meters by meters.

Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.technological innovation,When the landing door is closed, the full width of the lifting passage opening should be covered.Limit switches should be triggered directly by the movement of the suspension cage or its related components.During loading and unloading, the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed mm.Burgas,The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.The pump body adopts an integrated pump station, all equipped with imported high-quality pump stations, which can also be selected according to customer requirements to meet customer ideal requirements.The verticality of the guide rail frame should meet the requirements of the specifications.