Newark Screw deep well pumpIntroduction to precautions

　　Basically, the reasons for the motor heating of the submersible slurry pump are the above items. If the motor heating occurs, you can find the reasons from the above items. However, it must be noted that if the fault is caused by electricity, people who do not know electricity should not repair it by themselves, so as to avoid people　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.Newark ,　　The ball or bearing of the motor is damaged.　　The operating environment is different: the key difference between the submersible slurry pump and the vertical slurry pump lies in diving. During the operation of the vertical slurry pump, some parts intrude into the pit and cannot completely invade the slurry; The submersible slurry pump can completely penetrate below the slurry level.Marcala,　　The purpose is to avoid water leakage of the pump, but the water seal may be damaged due to faults after being used for a period of time. Let&#;s learn how to replace the water seal.　　After meters, the sealing of the equipment can not bear the water pressure at this depth.　　Therefore, when the pump temperature is too high, so as to find out the root cause of the excessive temperature of the equipment in time, and then take relative measures to effectively solve it.

　　Will be scrapped. In addition,Newark Long shaft submerged slurry pump, since the length of the long shaft is generally fixed, the cut impeller is usually used. The cut isproject,　　 Next, you can place abrasive cloth on the glass or dry wood, and then grind the water seal of Boshan submersible slurry pump flat or turn it over for use. However,Newark Rubber lining submerged slurry pump, if the thrust rubber water seal is used, when　　 fold the three layers in half with self-adhesive butyl tape and gradually extend to the outside of the core. When winding, the tape shall be stretched twice, and then the three layers shall be folded in half with PVC tape to ensure that the winding part is not less than mm, and the positions of the three joints shall be staggered for a certain distance in order to prevent short circuit.　　However, there is also a disadvantage of using the auxiliary impeller sealing system, that is, it takes some energy on the auxiliary impeller of the submersible slurry pump, which is generally about %. However, as long as the planning is reasonable this part of the lost flow can be reduced. The slurry pump is mainly applicable to electric power, metallurgy and coal

　　 The submersible slurry pump needs to be inspected after reassembly. If the pulley needs to be rotated by hand, the pump shaft should not be blocked under normal conditions. In addition, the sound of collision between the impeller and the pump shell needs to be avoided.How many?,　　 if the removed gasket is seriously damaged, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly.　　 Determination of flow　　Some of them are OK. For irrigation and other purposes, in fact,Newark Booster pipeline pump, we choose to use larger flow. Let&#;s take a look at the method of selecting pumps.Newark 　　It should be /-/ between. When the packing is worn, the packing gland can be properly pressed. If it is worn too much it should be replaced. The whole commissioning process of the submersible slurry pump mainly includes the above five tasks, which are mainly to pay attention to the details and the phenomena occurred during the operation, and timely deal with the problems in time to avoid being on duty Accidents during operation cause losses.　　 After each use of the equipment, high-pressure water should be used to wash the pump and pipes. The washing can be stopped until the water has no impurities.　　Balance of.