OluBotouBasic knowledge of the product

Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position,OluLv Liang, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Olu,The cargo is .m.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.Ch’in-huang-tao,The connection method and angle between the wall bracket and the building structure should comply with the requirements of the user manual.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.Especially suitable for steel structured factories suitable for both indoor and outdoor installation.

Setting requirements: For construction electric elevators with foundations installed on roof slabs, floors, or other lower suspended structures, the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.And prevent it from starting normally. There should be no device that allows users to cancel warning signals.When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.new product,OluKalish,The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.The full height landing door should meet the following requirements: the net height of the landing door opening should not be less than m. In special circumstances, when the net height of the building entrance is less than m, it is allowed to lower the height of the lower door opening, but in any case, the net height of the lower door opening is not less than m. (Article of GB-)Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.

Electric elevators used in various places.Sampling inspection, but also have an overflow valve to prevent excessive system pressure during upward movementIs there a relevant rule requirement for the cleanliness of hydraulic stations?For customers to use and operate the lifting platform for a long time,OluDongzhou, normal maintenance is mainly focused on prevention especially if any damage or malfunction is detected and corrected or repaired in a timely manner. Careful inspection and maintenance at this time can save costs and avoid larger problems, resulting in costly repairs.Olu,Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.It is understood that the scissor type lifting platform is a widely used specialized equipment for high-altitude operations. Its shear fork mechanical structure provides high stability for the lifting platform, wide working platform, and high load-bearing capacity, making the range of high-altitude operations larger and suitable for multiple people working simultaneously. The lifting power is divided into V, V or V power supplies, diesel engines, using Italian and domestic hydraulic pump stations, and the table top is equipped with anti slip insulation buckle plates, which have anti slip, insulation, and safety features. Please rest assured to use.