CincinnatiGelsenkirchenHow to define the future development direction

occupying a relatively small area

The motor of the hydraulic guide rail lifting platform is set around the wellbore, improving the utilization rate of the wellbore area.Use floor doors and cage door devices on construction sites where conditions permit.Cincinnati,After the limit switch is activated, only professional personnel can restore the movement of the suspension cage.Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.Nove Zamky,CincinnatiYingze, the user unit should organize professional technical personnel to inspect the construction electric elevator monthly according to the standard requirements, all equipped with imported high-quality pump stations, which can also be selected according to customer requirements to meet customer ideal requirements.

The setting of the cable guide frame should comply with the user manual and regulatory requirements.m； When the lifting speed is greater than .m/s, after the upper limit switch is triggered by the hanging cage, the upper small safety distance L should meet the following requirements: L=+.V, where L is the upper safety distance; V: Increase speedWhen the door is closed, except for the gap between the lower part of the door that should not exceed mm, any through-hole and opening size related to the distance between any door and adjacent moving parts, as well as the gap around the door or the gap between parts, should comply with the provisions of Table of GB -.Safety and health,When the landing door is closed the full width of the lifting passage opening should be covered.Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods, electric elevators should stack the goods neatly, which is better than stacking them in the center of the cargo stacking area of the cargo elevator to avoid imbalance between the two ends of the stacking area. Eventually,Cincinnatimalpensa airport , during the operation of the electric elevator, it may cause the electric elevator to lose balance. After the goods are stacked completely, ropes should be used to lock the goods, so that they are not afraid of the goods during the lifting process; Careless; Scattered downDrainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).

Acceptance: Concrete strength grade C, strength testing report.management,Setting requirements: The wall bracket should use the manufacturer's matching standard products.Items and other miscellaneous items.The advantages and disadvantages of several commonly used electric lifting mechanisms are as follows: hydraulic electric lifting mechanisms: using hydraulic technology, smooth lifting and low noise.Cincinnati,Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.Safety grounding device. In order to protect against electrical equipment. The metal casing of electrical equipment and the metal structure of electric elevators should be equipped with a safety grounding device. The grounding wire should operate multiple wires, and the neutral wire should not be arbitrarily held as a safety grounding wire. Its grounding resistance should not exceed ohms; The power supply of the electric elevator can be cut off.The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.