DortmundElectric mobile hydraulic lifting platformHow to perform preventive maintenance

Check the rollers, intermediate shafts, and bearings; Oil cylinder pin and bearing; Equality and wear of the hinge shaft and bearings of the boom; Fill the above components with oil. The service life of bearings can also be greatly enhanced.Support is an important preparatory work for elevator operation. The elevator should choose a flat ground, such as a foundation or uneven terrain, and must be padded with sleepers before proceeding with work.Dortmund,It is stipulated that measures should be actively taken for renovation.The elevator uses high-strength and high-quality profiles, which are sturdy, not easily deformed, and can support high-altitude operations to higher heights. This device can perform various operations in many fields and is widely used in factories, hotels, restaurants, stations, airports, cinemas, exhibition halls, and other places. It is a safe choice for maintenance equipment, painting decoration changing lighting fixtures, electrical appliances, cleaning and maintenance,DortmundHydraulic direct lift platform, and other purposes.Engels,Drain and discard the hydraulic oil, tighten the joint, remove the oil filter, clean it with compressed air, and then return it to the oil tank and connect the pipeline.How should the elevator be maintained? We have a lift that has been in use for a while but it's not working properly. Do you know the reason? This is because the elevator needs to be maintained after being used for a period of time. Let's take a look at the maintenance process of the elevator: () During monthly maintenance of the elevator, personnel must enter and work inside the elevator, and the elevator must be suspended to prevent sudden lowering of the elevator and causing casualties.Driving under the influence of alcohol is strictly prohibited and ongoing high-altitude operations should also be terminated if feeling unwell.

The general order for maintenance is to start with the lower arm, then the middle arm, and then the upper arm.The hydraulic working system of the elevator mainly uses hydraulic pumps for power, so the hydraulic system of the hydraulic elevator needs strong sealing performance. Firstly, it prevents air intrusion and secondly, water intrusion. Air intrusion can oxidize the hydraulic oil, and if there is too much air, the hydraulic system cannot function properly; The invasion of water can emulsify the hydraulic oil, causing its function to fail and increasing the wear of the hydraulic cylinder. Due to the fact that the majority of customers cannot ignore it, it is necessary to replace the emulsified hydraulic oil of hydraulic elevators in a timely manner. If impurities are found in the hydraulic system, it is necessary to clean them in a timely manner, so that the hydraulic oil can be considered and the hydraulic components can be cleaned one by one.During the rotation operation of the elevator, it is necessary to raise the lower arm to a certain height before starting the rotation. The rotation should be slow, and attention should be paid to whether the distance between the shear arm and the platform to each equipment meets safety requirements.Quality assurance,Elevators play an important role in handling, construction, and other operations, providing convenient transportation equipment. More and more elevators are being put into use in the market, but unstable voltage can have a certain impact on elevators during use.How should the elevator be maintained? When carrying out elevator maintenance, we should not only perform monthly maintenance, but also conduct year-end maintenance. The inspection positions for year-end maintenance and monthly maintenance are different, and we need to take into account both when carrying out maintenance.Enhance the lift function

The fault diagnosis equipment on the elevator can inform the operator of possible errors. The chassis is high and suitable for walking on rough surfaces. Planning is practical, reliable, and easy to repair and maintain. Diesel powered models have two wheel, four wheel drive, and steering. Free turning equipment. Urgent descent system. The operation height ranges from meters to meters, with advanced equipment and high-power power.Online consultation,Drain all the hydraulic oil in the oil tank, open the oil tank, take out the oil suction filter, clean it, and return it to the oil tank. Install it in its original position. Fill the fuel tank with new oil.In environments with relatively low temperatures, the maintenance work of the elevator needs to be done well. To prevent hydraulic oil from freezing, we suggest replacing it with hydraulic oil of size at the beginning of winter to ensure the normal operation of the lifting platform hydraulic system. In winter, the steel used for lifting platforms must not only meet the requirements of impact toughness, but also meet the requirements of strength. In order to cope with the impact of low temperature, the welding structure of each load-bearing component of the lifting platform on welding thermal stress, stress concentration, etc., and the state will also be different from ordinary conditions, so that some corresponding adjustments can be made before mechanical use.Compact structure, small size in transportation status, able to enter the car of general elevators, as well as smooth door openings and narrow passages.Dortmund,DortmundHydraulic lifting unloading platform equipment,Double masted lifting platform: The new generation product of the design is made of high-strength aluminum profiles. Due to the high strength of the profiles, the deflection of the lifting platform is minimal. Adopting a double mast column structure, it has a large load capacity, a large platform area, flexible operation, and convenient implementation. Its appearance allows for high lifting capacity in extremely small spaces. This elevator is widely used for three masted lifting platforms: three sets of masted support work platforms lift synchronously, with super large load capacity and work stability. The overall lifting guardrail device has good strength and greatly reduces the height of the entire machine during transportation. It is very convenient for loading and unloading and can be assembled or disassembled in one lift. The elevator has a strong load-bearing capacity and is suitable for two people (who can carry a certain amount of weight tools and materials) to climb high at the same time; Various non-standard products can also be customized according to different environments to meet different needs.Before the lift operation, the person in charge of the work should explain the technical and safety aspects to the operator. The website content should include: the content and requirements of the work website; Safety precautions and danger points; Personnel division of labor and scope of responsibility.Introduction to the characteristics, classification, and different uses of elevators: The overall use of high-strength aluminum profiles is refined. Due to the high strength of the profiles they have the advantages of beautiful appearance, small volume, light weight,DortmundHydraulic elevator price, compact structure, stable lifting platform, easy operation, safety and reliability, making high-altitude operations more convenient and fast. They can walk quickly and slowly, can adjust speed, and have a column lifting system with a large load capacity Strong stability, large platform area, and convenient implementation. It is the ideal high-altitude work equipment for modern enterprise safety production. It can be divided into single column, double column, and four column.