CologneVertical slurry pumpAnalysis and Research on the causes of cracks

　When using the submersible slurry pump, the equipment may be burned out. The main reason for this phenomenon is improper operation. How should we prevent the burning out?　　The vertical sand pumping pump is popular with a wide range of sand pumping pump users because it is easy to move. This equipment is made of high-tech endurance data. Its service life has been greatly improved and the maintenance frequency has been reduced, and the income has been increased.Cologne,　　 The WQ submersible sewage pump has compact overall structure, small volume,CologneWear resistant slurry pump, low noise, remarkable energy-saving effect and convenient maintenance. It can work by diving into the water without building a pump house,CologneDouble suction slurry pump, greatly reducing the project cost.　　Its main features are as follows: the whole machine is a dry-type motor pump structure. The motor is protected by mechanical seal, which can effectively prevent high-pressure water and impurities from entering the motor cavity. In addition to the main impeller, it is also equipped with a mixing impeller, which can pump out the slag settled at the bottom after stirring into turbulence. impellerAsbe Teferi, mechanical seals occupy an increasing share in the slurry pump seal market.　　The input quantity is related to many factors such as the rotating speed of the submersible slurry pump, the bearing standard, the continuous working time, the number of stops and starts of the pump, the surrounding environment and the working temperature. Therefore, it is necessary to gradually accumulate the experience and add smooth oil in a reasonable and timely manner.　　Potential is convenient and flexible. It is easy to operate. It can be operated by a fool who turns on the power supply under immersion; It has a wide range of applications. In many cases, it belongs to a portable workstation, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.

　　What?　　The motor burns out the winding due to heat dissipation. The water pump shall be lifted and lowered at any time with the change of water level in the well. In case of water reduction or interruption, the cause shall be found out immediately or the pump shall be shut down for inspection. The cable shall not rub against the shaft wall to prevent the well water from penetrating into the motor along the cable core after the cable is worn.　　Whether the pump is evacuated or overflowed etc., and handle it at any time.technical service,　　When using the submersible slurry pump, we should do a good job in all aspects of commissioning and precautions. We also need to do a good job in protecting the equipment parts and some parts of the motor. Only in this way can we avoid the impact of water and other impurities entering the motor　　Then it can enter into the volute pump housing. Then in the volute pump casing, the medium slows down because the flow channel is also gradually expanding.　　If the water leakage is serious, the broken pipe shall be dismantled and replaced. Lower the lift and press the nozzle of the water pump into the water for .m.

　　The hardened mud layer collapses after softening, avoiding the phenomenon of burying the pump during use.How much does it cost?,　　It is not correct that it has no effect on us.　　Correct the main shaft of the water pump and adjust the position of the water pump and the motor relatively.　　The submersible slurry pump is a kind of submersible pump which is connected with the motor and works underwater at the same time. In addition, compared with horizontal slurry pump and vertical slurry pump,CologneFire deep well pump, submersible slurry pump has the great advantage of flexibility and convenience, and is more suitable for various working conditions. The important technical points of submersible slurry pump are its motor andCologne,　　Second, the service life of the flow passage parts of the pump is relatively long, saving production costs.　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.　　The Tao part also consumes part of it.