Berlin6-meter electric elevatorAnti-collision energy and effect

Berlin10 meter electric lifting platform,

Every theater is a public place with a large number of people, and safety considerations should be taken into account in stage design. According to relevant national regulations, in order to prevent accidents caused by the crushing of electric elevators or improper control by drivers. Electric elevators should be equipped with the following necessary safety devices to ensure that the car of the electric elevator stops rising or falling in a timely manner.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.Berlin,The coaxiality between the motor shaft and the worm shaft in the aluminum alloy electric elevator drive device should be less than .mm, and there should be a mm gap at the shaft end to ensure that the motor bearings bear reasonable loads and reduce motor operating noise; electricSetting requirements: The main connection methods between the wall bracket and the building include: connecting the wall bracket with the embedded parts on the wall; Fix with wall bolts; Embedded bolts; Welding with steel structures.Garzwin,News Abstract: The development of the lifting platform industry will continue to grow in recent years! With the continuous development of electric lifting machinery for high-altitude operations in recent years, the products of electric lifting platform vehicles have been continuously improved,BerlinSmall car electric elevator, and various new technologies and materials have emerged, making the further development of lifting platform vehicles possible.Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.In addition to ground protective fences, a half height middle crossbar, and a toe board at least mm above the ground.

Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.m； When the lifting speed is greater than .m/s after the upper limit switch is triggered by the hanging cage, the upper small safety distance L should meet the following requirements: L=+.V, where L is the upper safety distance; V: Increase speedThe verticality of the guide rail frame should meet the requirements of the specifications.Sampling inspection,Chain type electric lifting mechanism: With a good guiding mechanism,BerlinSelf propelled electric elevator, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.During loading and unloading, the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed mm.Installation and dismantling personnel and drivers should hold certificates to work.

The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side, and the door bolt must be set on the side next to the construction electric elevator.offer,There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Setting requirements: Buffers should be installed below the suspension cage and counterweight running channel.Setting requirements: The installation and dismantling workers,The foundation base or embedded parts should be fully embedded in the concrete foundation plate.Construction electric elevators outside the lightning protection rangeSetting requirements: For construction electric elevators that operate in multiple shifts and other operators of construction electric elevators should have special construction operations.Berlin, the handover system should be implemented, and drivers should fill out the handover record form according to the standard requirements. The driver should conduct a pre shift inspection and confirm that there are no errors before starting the machine for operation.