kgirls brass plateQuality inspection method

Insert the pipe into the top of the bayonet,e the sleeve on the pipe to evenly apply the flux on the joint, and confirm that the pipe is inserted into the bottom of the socket, then wipe off the excess flux, and the joint is assembled and can be heated.Advantages of red copper tube Durability: copper has stable chemical properties, integrating cold resistance, heat resistance, pressure resistance, corrosion resistance and fire resistance,In addition, not easy to be corroded, and can adapt to various environments. It can be used normally at low and high temperatures, so copper pipes need to be selected many times in other places. The color change on the outer surface of the copper tube is difficult to control due to environmental factors. To prevent moisture absorption on the surface and core of the annealed brass tube, a constant temperature and humidity packaging room can be built. Packaging in the packaging room can avoid the color change on the outer surface of the copper tube. However, it is not easy to control the situation that occurs in the processing process. The cost of ensuring constant temperature and humidity in the whole workshop is too high. The following measures are taken to control the process materials: In the season of high temperature and humidity, during the production and processing of copper tubes, the amount of oil coating on the surface of copper tubes can be increased to form an oil film on the surface of copper tubes, which can isolate water vapor and corrosive gases, and prevent the corrosion of the surface of copper tubes; The humidity in the air at night is high,kgirls T2 copper bar, and the outer surface of the copper pipe is prone to corrosion and discoloration at night. Closing the doors and windows of the workshop at night can make the situation worse; After the coil surface is cleaned in the rewinding process, the coating amount of passivation agent on the copper tube surface is increased. After blanking in the rewinding process, plastic bags shall be added to the whole support material to further reduce the contact between the copper pipe and the air and prevent the surface of the copper pipe.Overview of three production methods of copper tube Copper tube is a very important material for copper materials. There are many ways to complete the production of this copper tube. For copper pipes, but also very convenient to operate. There are three production methods for copper tube, so what are the three production methods for copper tube?Galiganj,Generally,kgirls Square aluminum tube, oxygen aylene is used as the gas source and LPG welding tool is used for heating. The torch of the welding tool shall face the joint and then continuously heat the whole joint. This will avoid excessive local heating.At present,kgirls 316L stainless steel coiled plate, the fundamentals faced by the domestic copper bar market are still mixed. On the one hand, the market supply is expected to shrink, but on the other hand, the northern market has entered the off-season of demand, and the market s expectation of future demand is pessimistic. In the short term, domestic steel prices will enter the operating track of range consolidation. To sum up, considering the current situation of demand and inventory in the steel market, it is difficult for the steel market to make a breakthrough. As the th National Congress of the Communist of China is approaching, environmental protection phenomena such as steel mills are still going on, and black series speculation is still taking place. But personally, the fluuation range of the market in this region is limited, and businesses can operate flexibly on a short-term basis, and the shipment transaction is * * *.Advantages: good quality, fine structure, high density, high pressure resistance, large bending deformation, suitable for frequent cold and heat exchange, large temperature difference in working environment and large size copper tube can be produced.

Among the three production methods of copper tube, the oxidation method is the most. Because as long as the metal copper is oxidized by the anode and the copper ion of the anode is attached to the tube material, the copper tube can be produced. Thisthod is also the most common method to produce copper materials. It has not only been used for a long time, which is to produce copper tubes through oxidation reaction. This production method is the main production method of copper tubes in China.Hot water accelerates the corrosion of copper pipes.Disadvantages: Due to loose tissue and high pressure resistance, the pipe is only used to produce small air conditioning copper rods.production costs,antages: low production cost and high production efficiency.In consideration of the above factors, more and more steel plants have stopped production since October, and the production limit in Wu an and Tangshan heating seasons has been advanced. In addition, the formal implementation of production limit in & quot; +& quot; urban heating seasons after November by steel enterprises, the demand for iron ore in the future is likely to further deteriorate. The iron ore inventory of the steel plant is relatively high, and the willingness to further replenish the inventory is not strong. In terms of supply, the fourth quarter is generally the peak period for the shipment of imported ores. Although the production of domestic mines has been reduced due to environmental protection, the quantity of * * * is relatively limited. In general, the short-term iron ore market may lack upward momentum.If you want to avoid this kind of situation for a long time, you can choose passivation treatment. In this way, not only is the copper surface serious, it can be cleaned under normal circumstances, but it is not a big problem to keep it in the air for one year or more after ultrasonic treatment and immersion treatment, so this effect is very good.

Red copper bars in other regions basically follow the price trend of Tangshan, in which the bid of Jiangsu Steel Works tends to be higher, and most of the downstream prices are asked and the overall market transaction is fair. The steel mills in Wu an are limited in receiving orders, and the market resources are tight. Most of the merchants are reluctant to sell. Shanxi billet market offers vary, and it is difficult to clinch a deal. The willingness of downstream customers to receive orders is weak, so they hold a cautious wait-and-see attitude. At prepresent, the steel market is in the & quot; golden third& quot; peak season. The market has a good expectation of the future market and a strong willingness to support prices. It is expected that the prices of Tangshan mainstream billets will be stronger next week.Recommendation and consultation,Today, the price of tube billets is up and down. At present, Jiangxin hot rolling is yuan, continuous casting yuan is down yuan, Dongfang hot rolling yuan is down yuan, Luli hot rolling yuan is down yuan, Tiangang hot rolling an is down yuan, production is stopped in mid January, Weigang hot rolling yuan is up yuan, continuous casting yuan is up yuan, Huaigang yuan is up yuan Zhongtian yuan, Changqiang yuan, Linggang yuan.Water quality, water flow and flow of the pipe.Generally,The production method of soft copper tube is basically the same as that of hard copper tube, the annealing process is added compared with the hard copper tube. Annealing of copper tubes means that they are calcined in a high temperature furnace to change the arrangement of the elements in the copper tubes. However after annealing, the copper tubes will become soft, which makes it easier to bend. The copper tubes produced in this way are called soft copper tubes.In the middle and late ten days, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level, traders had no desire to increase prices, most of them had shipped goods, and spot prices lacked motivation to rise. The market inventory rose significantly. At that time, the market inventory in Handan reached a high level after the festival. The sluggish demand performance for a long time led to the oversupply of the market and the continuous rise of inventory led to the empty market mentality.So far as the storage method of copper materials is concerned, we should properly keep the copper products we buy, extend the service life of copper and ensure its performance to avoid unnecessary losses.