Saint Jerome Corrosive pipeline pumpApplicable environment analysis

　　Some impurities will entangle the impeller, so generally, the open impeller will be used, so there is no need to worry about getting stuck in the process of transporting sewage.　　There is no need to equip auxiliary mixing or spraying equipment, and the operation is simpler. The equipment is directly submerged for operation, without noise and vibration, and the site is cleaner.Saint Jerome ,　　The microcomputer controller displays E: cause: the pressure gauge is disconnected (f= or the input signal is

　　Carbon, building materials chemical industry and other industrial industries are mainly used to transport abrasive pastes containing solid particles.　　There is no suction line. As the water storage tank is not deep enough and the suction pipe of the water pump is not deep enough, the inlet pipe of the water vortex is not deep enough. Water with a lot of gas. Destroy all normal water Self-priming pumps. To ensure sufficient depth of digestion and absorption of low watermark water. At that time, the depth was .~lm, and it was impossible to　　The purpose is to avoid water leakage of the pump, but the water seal may be damaged due to faults after being used for a period of time. Let&#;s learn how to replace the water seal.Honest management,　　In addition to the method, anti cavitation theory, corrosion mechanism of water pump and stress characteristics. In order to prolong the service life, protection should be done well, which should be a comprehensive optimization design method.　　The submersible slurry pump may be blocked when it is used at ordinary times. In particular, some equipment is frequently used at ordinary times, but the maintenance work is not done well when it is used, so it will be blocked after being used for a period of time　　What?

　　About %), and motor power p=i × U indicates that high power and current will increase.Click to view,　　 The pump body (can not) bear the pressure from the outlet pipeline system. The standby pump in the warehouse should rotate (/ times a week to make the shaft bear the load and external vibration evenly. The belt CR drive is that the motor is on the (right) side of the pump from the inlet of the pump.　　For example,Saint Jerome Split vertical pipeline pump, the lubrication method, the number of impellers, the number of bolts and other small details determine that these slurry pumps are not used.　　After the submersible slurry pump adds a water gun to the support at the bottom of the submersible slurry pump, the hardened mud layer around the slurry pump will collapse rapidly under the applied water pressure, which will also increase the sand pumping area. This will also increase the sand pumping area,Saint Jerome ,　　Some corrosive pastes containing crystals can also be transported. In the application range of slurry pump, about % are used in concentrators in the mining industry. Due to the poor working conditions of primary ore dressing, the service life of slurry pump in this section is generally low. Of course, different minerals, abrasion　　 The secondary pump shaft seal of the two-stage series pump is (packing seal),Saint Jerome QJ submersible pump, and the startup of the series pump also follows the above method. Only after the first stage pump is started the submersible slurry pump can open the outlet valve of the last stage pump (the opening size is based on the motor current of the first stage pump as the rated power　　Causes: there is air or gas accumulation in the water inlet pipe of the pump, or the bottom valve is not closed tightly, the water supply is not satisfied, the packing of the vacuum pump leaks seriously, and the gate valve or flap valve is not closed tightly.