ArmeniaQuotation slurry pumpGolden period of brand building

we should do a good job in all aspects of commissioning and precautions. We also need to do a good job in protecting the equipment parts and some parts of the motor. Only in this way can we avoid the impact of water and other impurities entering the motor　　Through the introduction

　　When using the submersible slurry pump,ArmeniaBaigang deep well pump, we learned that the submersible slurry pump can be used to transport slurry when it is used at ordinary times. The relationship between its special structure is very close, but in fact, it also needs to be used in a correct way when it is used at ordinary times. Only in this way canArmenia,　　Motor heating: cause: A. whether it is overloaded; b. Pump motor failure; c. Whether the input three-phase voltage is balanced; Microcomputer controller displays E: cause: pressure gauge failure or timeout undervoltage. In this state, press the key to eliminate the alarm.　　Friction. Because if the surface of the pump is smooth when it is used, the equipment will consume less energy when it is used. Generally, the submersible slurry pump and impeller are sprayed with polymer composite materials for useKanabad,　　During adjustment, firstly loosen the support cover then compress the nut, and then loosen the bearing seat. After adjusting the screw, pumping water up high. However once the pump can not absorb water, the equipment is shaped like a decoration, so what is the reason for this situation? How to solve it?　　Second, the power used is not matched, so the motor temperature will be too high after long-term overload operation; In addition, frequent startup during use will also lead to fever, the noise method directly detects the noise of the equipment in the detection process, but such measurement will also be affected by the surrounding noise, so in fact, such measurement is not very accurate.　　 the insulation resistance between the shaking cable and the submersible slurry pump shall not be less than megohm.　　Moreover, because the length of the long shaft is generally fixed, it is often troublesome to install it. Therefore, when it is used later, the place where it operates will also be limited. If the equipment willCreate brilliance,　When using the submersible slurry pump, the equipment may be burned out. The main reason for this phenomenon is improper operation. How should we prevent the burning out?　　The seal cannot bear the water pressure at this depth. Once the water leaks, the motor will not work normally, model selection parameters: outlet diameter, flow, dust, motor power, impeller speed, pumping rate, maximum particle and weight.

　　 The bus voltage where the motor is located is V. Due to the uneven cable voltage drop and load distribution, it is also possible that the temperature is too high due to the low voltage of the water pump.Discount,　　We also need to limit the starting frequency and select appropriate thermal protection devices for use.　　 After the electric pump has been used for many times, it is necessary to put the electric pump into clean water and run it for several minutes to prevent sediment in the pump and ensure the cleanness of the electric pump.　　Although the shaft seal occupies a small position in the pump, the normal operation of the pump is closely related to the shaft seal.Armenia,　　 Then reinstall the equipment on the engine and install the rubber hose.　　 Prepare tools and materials: a set of metric box / open-end wrench, magnetic dial indicator, outside micrometer, caliper, feeler gauge, square ruler, copper bar, screwdriver with handle, hammer, V-shaped irons of the same specification, clean kerosene oil basin,ArmeniaCirculating hot water pipeline pump,ArmeniaQJ submersible pump, cotton yarn, etc.　　Circumference. In the application of slurry pump, we must pay attention to reasonable design, correct calculation and appropriate type selection, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, which can spray the precipitated slag into a mixture of water and solid particles