RomeFire deep well pumpHow is the degree of oxidation affected

　　What stands out is the sealing of the container. The seal is easy to install and maintain, stable and reliable, but the price is quite expensive.　　 for screws that are too tight or rusted for a long time the nut can be lubricated with kerosene prepared in advance, or the nut can be gently knocked with a wooden hammer and then removed. This method can also be used in slurry pumps and other places.Rome,　　 Use a V insulation resistance meter to measure the insulation resistance between phases and phase to ground of the electric pump motor, and the value shall not be less than m Ω. Otherwise, the motor stator winding shall be dried, and the drying temperature shall not exceed ℃.　　Work, no noise and vibration, and the site is cleaner.Jamaame,　　It is also necessary to clean the ventilation duct to avoid blockage.　　The supply of shaft seal water must be ensured. It is strictly prohibited to operate without water,RomeISG single stage vertical pipeline pump, otherwise the mechanical seal will be burned.　　 the front and rear bearing glands are equipped with oil seals, which are padded with green paper or asbestos. There is a gap of .- mm between the rear gland and the bearing.

　　Vertical slurry pump is an early product. Submersible slurry pump is a new product developed with the improvement of social demand and operating environment.　　Pipeline pump is also called pipeline centrifugal pump. According to the structure, pipeline pump can be divided into vertical pipeline pump and horizontal pipeline pump. Can the pipeline pump suck water? Recently, a customer asked this question. Most pipeline pumps have self-priming . It&#;s just that different types of pipeline pumps　　Friction resistance due to bearing and packing; Friction between impeller and water during rotation; The vortex of water flow in the pump, gap reflux, inlet and outlet impact and other reasons. A part of the power must be consumed, so it is impossible for the water pump to completely change the power input by the power machine into effective power, in which the constant active powerSafety production,RomeRubber lining submerged slurry pump,　　 install a valve to inject water at the water inlet and outlet. This method is to install a valve on the water inlet pipe of the submersible slurry pump and connect the water pipe to inject water into the pump. This is a common and simple method.　　The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss.　　If the water leakage is serious, but when it is serious, it will directly burn out the insulation; There may also be some faults in the ventilation system. At this time,RomeZD slurry pump, it is necessary to check whether the fan of the submersible slurry pump is damaged or rotatingQuality risk,　　Then it can enter into the volute pump housing. Then in the volute pump casing, the medium slows down because the flow channel is also gradually expanding.　　The treatment method is as follows: try to ensure the stability of the water pump during installation, and the water pump should not be installed too high.　　 If the pump is equipped with a vacuum gauge or pressure gauge, close the cock connected with the submersible slurry pump before starting the motor, open it after the speed is normal, and then gradually open the outlet sluice valve. If the flow is too large, if the flow is too small,Open the gate valve.Rome,　　What is the solution to this situation?　　If the oil seal ring of the shaft is seriously worn, replace it with a new one.　　Now you know the reason why the pump has air turbidity. In fact, such as water oil, liquid metal, acid-base night and so on. It is a good means of transport.