BudapestFully electric self-propelled elevatorTo improve the mold

Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.Double layer steel mesh: The diameter of the steel bars is mm, with a spacing of mm.Budapest,The occurrence of.When the wall bracket adopts non matching standard products, design calculations should be carried out.Gitega,Use floor doors and cage door devices on construction sites where conditions permit.Low power consumption: When the hydraulic guide rail lifting platform descends, it is driven by the pressure generated by its own weight, greatly saving energy and reducing consumption.Electric elevators used in various places.

Safety performance: Electric elevators not only have the safety device of traditional traction elevators,BudapestElectric fork lift table,Budapest22ov electric elevator, but also have an overflow valve to prevent excessive system pressure during upward movementCorrect use can also greatly improve work efficiency. So how should it be used?Spiral electric lifting mechanism: With all the functions of a regular lifting platform, the main feature is that the equipment occupies a small foundation pit and has a large stroke. The equipment has a height of only -mm and a travel distance of up to m. It is particularly suitable for buildings with stages built on two or more floors due to space constraints.Discount,Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width and should not open towards the lifting passage.Manual pump: When the system malfunctions,BudapestHigh altitude electric elevator, the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor positionWhen the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.

Model Example: Hanging Cage Specification: LABSC/TDx Type I: ~ Type II: ~ Type V: ~ Technical Requirements: The load-bearing capacity of the foundation should be greater than P: P=(hanging cage weight+outer cage weight+total weight of guide rail frame+counterweight+load) x. (kN).Create brilliance, resulting in a safety clamp. To prevent breakage of the lifting wire rope. A safety clamp that can simultaneously cut off the power supply and stop the car from falling should be removed from the car. A car without safety tongs is not allowed to ride or carry people. If it is a simple electric elevator, there should be a safety device (such as a safety stop pin) to prevent people from suddenly falling when loading and unloading goods in the car; Electric elevators with three or more floors (including three floors) for passengers or passengers.. The shutdown device (emergency stop switch) should be installed outside the ground protective fence; b) Pulley room (if any. Pulley room refers to a room where only pulleys or speed limiters and electrical equipment are installed; c) hanging cage top, ifModel Example: Hanging Cage Specification: LABSC/TDx Type I: ~ Type II: ~ Type V: ~ Technical Requirements: The load-bearing capacity of the foundation should be greater than P: P=(hanging cage weight+outer cage weight+total weight of guide rail frame+counterweight+load) x. (kN).Budapest,The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.When a rigid mm square or circular flat surface is applied with a normal force of N to either side of the door, but safety should be maintained.