Mezek WadeQuotation slurry pumpApplication skills of

　　For example, in the market, for example, the sweeping pump, some of which have a depth of more than meters, it is not suitable to use a vertical slurry pump under such a working condition, but it is extremely easy to use a submersible slurry pump.　　Wheel, mixing impeller and other main flow passage parts are made of high wear-resistant raw materials, which are wear-resistant, corrosion-resistant, non clogging, and have strong sewage discharge capacity, and can effectively pass through large solid particles. It is not limited by suction range with high slag suction efficiency and more complete desilting. There is no need to equip auxiliary vacuum pump, and the investment is lower.Mezek Wade,　　 If the deep well pump is not used continuously after running in the well, it should be started up once a week and run for - minutes to prevent the electric pump from being started due to corrosion.　　Rate loss, so shaft power = effective power + lost power.Glodeni,　　 First remove the pump from the engine.　　Compared with the vertical slurry pump, the submersible slurry pump can also be used as a mobile slurry pump, such as sand pumping on board, prospecting, etc; Submersible slurry pump assembly workshop III. what are the advantages of submersible slurry pump　　The structure of the submersible slurry pump will be more intuitive. First, the equipment will use centrifugal force to drive the liquid from the impeller to the outer edge and obtain energy,　　Water flow into the bearing damages the bearing.　　It is an auxiliary means for some on-site monitoring.　　The above is the correct sequence of impeller disassembly of submersible slurry pump. Because different types of pumps have some differences in structure which is measured by η Indicates.device management which is measured by the pump efficiency. The pump efficiency is the ratio of the effective power and the shaft power, we also need to refer to the instructions when disassembling.

　　Slurry pump Inappropriate model is selected when selecting the pump. In actual use,Mezek WadeQJ submersible pump,Mezek WadeISG single stage vertical pipeline pump, when the load conditions do not match the model of the slurry pump, for example, the pump lift used is too high or too low, which will lead to overload, so we are selecting the pumpwhere,　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.　　 Pipeline booster pump: in fact, the pipeline booster pump is what we often call a booster pump. It is named according to the purpose of the pump. As the name suggests, any pump that can pressurize the liquid delivered in the pipeline can be called a pipeline booster pump. Not limited to one type of pump, such as centrifugal pump, pipeline　　The submersible slurry pump may be blocked when it is used at ordinary times. In particular, some equipment is frequently used at ordinary times, but the maintenance work is not done well when it is used, so it will be blocked after being used for a period of timeMezek Wade,　　For example, concentrate and tailings are treated in the concentrator, ash and slag are removed from the power plant, slime and dense medium coal are transported in the coal preparation plant,Mezek WadeWater well pipeline pump, and slurry is transported in coastal river mining operations. The weight concentration of the treated slurry is: mortar %, ore slurry %; It can be operated in series according to the needs of users.　　Do not exceed the rated current.　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.