EdHousehold sightseeing elevatorWhat is the role of maintenance

Please note that there should be a space of over mm left on both sides of the escalator, and when arranged in parallel, there is no restriction between the two escalators.Measure the beam edge distance between the upper and lower support beams. The measurement is to suspend the line from the upper support point to the ground for positioning and then measure the horizontal distance from the positioning point to the edge of the lower support beam.Ed,Household elevators have gradually become an essential vertical transportation tool for modern single family,EdSmall sightseeing villa home elevator, duplex, multi story, villa and other residential buildings, practical and convenient, and even a beautiful scenery in the home.The household must make two steel splints above the entrance. The position and size of the clamp plate are determined based on the selected door machine model.Huarmey,The beam edge distance is too small: The method of shortening the lower platform is to shorten the total length of the escalator, but note that the range of shortening is very limited, generally not exceeding mm. Generally, the platform cannot be shortened because it contains equipment such as cabinets and motors. Change the angle of the escalator from degrees to degreesRestore the command button function in the cabin for firefighters to operate.If the elevator is already on the first floor, immediately open the elevator door and enter the firefighter's dedicated state.

There are dedicated operation buttons for firefighters at appropriate positions at the entrance of the first floor elevator. The operation buttons are generally protected by glass sheets and have a red&# quo; mark in place; Dedicated to fire protection; Words such as.Slide elevators are installed inside buildings and are often used parallel to buildings and sidewalksIf the elevator is already on the first floor,EdHigh altitude reclaimer, immediately open the elevator door and enter the firefighter's dedicated state.Convenient and efficient,The requirement for the shaft is that it should not be plastered, which is beneficial for reducing noise, width, and depth of the pit (if any), and observe whether there are grooves and embedded parts at the support beam.The basic content of escalator shaft measurement is to measure the lifting height. The same as measuring the height of a straight ladder, the lifting height of a ladder is the vertical distance between the finished ground at the upper and lower support beams. When using the suspension line method to measure, attention should be paid to whether there is a drop between the positioning point of the line drop and the decoration surface of the lower support beam of the ladder.

　　“& rdquo; Elevator shaft: The design conditions are provided by the user to the architectural design department. The architectural design department analyzes whether the on-site pit depth, reaction force, etc. can meet the installation requirements of the elevator, as well as which building structures are needed (such as smashing stairs or floors), and develops a renovation construction plan. If it is indeed necessary to change the elevator structure due to civil engineering conditions (such as car size, door opening width, etc.), then consider the non-standard design of the elevator.Welcome calls The speed limiter tensioning device and the steel belt tensioning device should be equipped with a safety switch.The elevator suddenly opens the door and does not move after leveling, but automatically resumes operation after a few minutes: The elevator (escalator) has been running for too long, and the motor overheats. To prevent burning out, the motor cools down and automatically resumes operation.The call button on each floor is no longer working and the call is cut off.Ed,Please note that there should be a space of over mm left on both sides of the escalator,EdStage hydraulic lifting platform, and when arranged in parallel, there is no restriction between the two escalators.Attention: The elevator consists of two main parts: mechanical and electrical. If the elevator is not maintained on a daily basis, its safety cannot be guaranteed. If the elevator needs to be refueled without refueling, it will cause wear and tear on the mechanical components of the elevator, greatly shortening its service life and preventing normal use of the elevator.There are dedicated operation buttons for firefighters at appropriate positions at the entrance of the first floor elevator. The operation buttons are generally protected by glass sheets and have a red&# quo; mark in place; Dedicated to fire protection; Words such as.