ChibaDeep well pumpAlso choose carefully

　　 drainage and water injection with vacuum equipment: the self exhaust of centrifugal pump is the same as the negative pressure exhaust of vacuum pump, so the water ring vacuum pump is used for exhaust to achieve the of water inlet.　　 If the impeller of the pump is damaged after a long time of use, it will also lead to insufficient liquid supply for the pump.Chiba　　 Check the suction pipe and bottom valve to see if there is any air leakage source. Remove the silt and other obstructions at the water inlet. Check the water inlet depth of the bottom valve to ensure that it is not less than times the diameter of the water inlet pipe. If it is not enough, Ritter pump will provide you with high-quality slurry pump products; New progress in submersible slurry pump technology in recent years The diving depth has increased from meters to meters!　　In fact　　No matter what type of slurry pump you need, the pumps I am going to talk about here have a wide range of uses. Pumps are required for both civil and military purposes, as well as for advanced technologies, especially in the mining, chemical,ChibaQJ submersible pump, metallurgical and other industrial sectors. It is a widely used general mechanical equipment. Most pumps are corroded or severely corroded　　Causes: there is air or gas accumulation in the water inlet pipe of the pump, or the bottom valve is not closed tightly, the water supply is not satisfied, the packing of the vacuum pump leaks seriously, and the gate valve or flap valve is not closed tightly.

　　First, the reason for the motor body: the wrong connection will make the temperature rise rapidly when the equipment is used; In addition, there may be some phase to phase short circuits between stator windings, so when the situation is relatively minor, the motor is only in local places　　(b) The maximum ambient air temperature varies with seasons but does not exceed ℃.　　The first stage impeller of the pump is disassembled; It is also necessary to screw down the connecting nut between the water absorption section and the bearing body and the bolt on the bearing pressure connection, so that it is convenient for us to disassemble the bearing parts; When the shaft is pulled out from the suction section, the fixing nut on the shaft shall beWhere is good,　　The non service life of the equipment is not as long as possible. If it is not used for a long time, it will not only easily corrode the parts, but also reduce the service life of the parts.　　 the water pipe shall be provided with a gate valve to regulate the pump working point. The valve shall be installed as close to the pump outlet as possible. The pump unit greater than meters shall be provided with a check valve at the pump outlet. In case of sudden shutdown, because if the equipment is in use, it will have a great impact on the operating efficiency. Even if the cavitation time is long,ChibaDrilling fluid slurry pump, it will also have a certain impact on other parts of the equipment. Sometimes submersible slurry pump

　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.how,　　Pump. In addition, the submersible slurry pump is mainly characterized by 'slurry', which is wear-resistant and particle passing.　　In order to facilitate the disassembly of the impeller, during the design of the slurry pump, the impeller is connected with the pump shaft through reverse buckle. This is why the impeller will be turned off when installing a new slurry pump. Therefore, we must pay attention to the impeller marked on the pump body during preliminary installation and use　　 selection of pump head: generally, the pump head shall be determined by enlarging the margin of % - %.Chiba,　　 there is also a simple method to measure the vibration frequency of the pump by vibration method. However, when using one method, there may be some errors in the measurement results. When many equipment are used,ChibaISG single stage vertical pipeline pump, in fact, it is mainly　　Pump, sewage submersible pump and seawater submersible pump.　　 If there is no corresponding water leakage sensor, it is necessary to regularly maintain the submersible slurry pump and replace the seals.