ClevelandZD slurry pumpWhat conditions are required for installation

ClevelandBooster pipeline pump,

　　Fourth, model selection parameters: outlet diameter, flow, dust, motor power, impeller speed, pumping rate, and the middle section including the guide vane; in addition, remove the impellers, middle sections and guide vanes at other levels in the same way until the submerged slag slurryCleveland,　　Typical applications: constant pressure water supply, fire protection, sprinkler, water supply and drainage, port machinery, machine tools, boilers, paper machinery, food machinery, etc.　　Slurry pump Inappropriate model is selected when selecting the pump. In actual use, when the load conditions do not match the model of the slurry pump, for example, the pump lift used is too high or too low, which will lead to overload, so we are selecting the pumpBukand,　　 if the removed gasket is seriously damaged,ClevelandPipeline pump, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly.　　 When starting the slurry pump, the outlet gate valve shall be (closed or slightly opened by /. Before starting the slurry pump, expand the pump inlet valve and close the pump outlet valve. Then start the pump. After the pump is started, and the operation is simpler. The equipment is directly submerged for operation, without noise and vibration,ClevelandBaigang deep well pump, and the site is cleaner.　　 Gradually disassemble the outlet pipe gate valve and elbow with installation tools, and tighten the next section of water pipe with pipe clamping plate. In this way, disassemble the pump section by section and lift the pump out of the well. (if it is found that there is a jam during the lifting and removal process, it cannot be lifted by force, and the customer service points shall be moved up and down, left and right for safe lifting and removal)　　Therefore,　　Then it can enter into the volute pump housing. Then in the volute pump casing, the medium slows down because the flow channel is also gradually expanding.　　The use of water pumps for agricultural drainage and irrigation can improve the ability of agriculture to resist natural disasters increase production and ensure income, and provide material conditions for agricultural mechanization and water conservancy.　　Work, no noise and vibration, and the site is cleaner.

　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.Packaging strategy,　　The operating environment is different: the key difference between the submersible slurry pump and the vertical slurry pump lies in diving. During the operation of the vertical slurry pump, some parts intrude into the pit and cannot completely invade the slurry; The submersible slurry pump can completely penetrate below the slurry level.　　 the resistance shall be greater than megohm after filling with water. Turn on the power supply to test the steering and mark the continuous position.　　Strong strength and other advantages. It is widely used as a sealing device for various pumps. Place a water seal ring at the bottom of the packing box, and then place the filler.Cleveland　　According to the user&#;s requirements, the motor can add a variety of protection devices such as water inflow detection and overheating, so that the product can operate safely for a long time under adverse working conditions.　　It should be /-/ between. When the packing is worn, the packing gland can be properly pressed. If it is worn too much, it should be replaced. The whole commissioning process of the submersible slurry pump mainly includes the above five tasks, which are mainly to pay attention to the details and the phenomena occurred during the operation, and timely deal with the problems in time to avoid being on duty Accidents during operation cause losses.　　The impeller of the submersible slurry pump may need to be disassembled for maintenance or repair during use. However, when we do not know the pump structure, we may make mistakes during disassembly. Let&#;s take a look at the correct disassembly of the impeller