Abu GhraibZD slurry pumpSelection of installation

Abu GhraibPipeline pump,

　　 If there is abnormal sound inside the slurry pump and there is no water it is likely that the equipment may have air infiltrating into it when absorbing water, which will cause abnormal sound inside the pump, and then at the same time, the impeller is damaged or the impeller is damaged　　When the equipment is in use, the water delivered in the pump receives the friction with the surface of the pump impeller, so the pump needs to consume more energy to reduce the friction and resistance caused by the surface when it is rotating. Water will slowly overcome it as it flowsAbu Ghraib,　　Test the steering first, and then connect the motor to the ash pump. There is a removal ring at the journal. This device can prevent the impeller from reversing.　　The purpose is to avoid water leakage of the pump,Abu GhraibSubmersible non clogging sewage pump, but the water seal may be damaged due to faults after being used for a period of time. Let&#;s learn how to replace the water seal.San Felipe,　　Then there are new structures, such as thermohydrodynamic seals, backup seals and asymmetric molded metal single wall bellows seals.　　Work, no noise and vibration, and the site is cleaner.　　 Move the sand pumping site frequently. When the pump pumps sand at a fixed position and drops to a certain height, lift the submersible slurry pump and move it to the adjacent position of the previous sand pumping place to continue pumping sand, so as to move the sand pumping place back and forth for sand pumping, so that the sand pumping area in this area forms a honeycomb,

　　Balance of.　　Requirements. Then install the pressure regulating film, pressure regulating spring and cover.　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.Inspection basis,　　If there are sundries blocked, the pump will not be filled with water. When this happens again, technicians need to properly adjust the liquid level in the pump sump to a proper height and check the impeller. In case of damage or aging, it needs to be replaced in time,　　Stop, then tighten the bearing seat, press down the nut, and fix the axial position of the rotor. The latter submersible slurry pump uses a barrel support, which generally does not need to adjust the impeller clearance. Therefore, if there is a problem with the clearance in the future use, loosen the support clamp first, and say that the nut is loose　　Some impurities will entangle the impeller, so generally, the open impeller will be used,Abu GhraibSubmersible sewage pump, there is no need to build complex ground protection and fixed devices, and the management is easier. The mixing impeller directly contacts the deposition surface and controls the concentration through the diving depth, so the concentration control is more free. Equipment directly submergedmiddleman　　 First of all, multiple pumps need to be used in parallel or standby pumps need to be prepared.　　Friends who are more concerned about this issue can dispel their concerns.　　 If there is no corresponding water leakage sensor, it is necessary to regularly maintain the submersible slurry pump and replace the seals.Abu Ghraib,　　 repair and level the welding part of the submersible slurry pump with a file, clean the part to be bound with alcohol again and wipe it dry.　　 Protective packing of shaft seal the shaft seal pump shall regularly check the sealing water pressure and water volume, regularly adjust the packing gland, check the packing and regularly replace the packing. The shaft seal water pressure and water volume shall meet the above (shaft seal inspection) requirements.　　 Then reinstall the equipment on the engine and install the rubber hose.