Ghazi Abad Used pipeline pumpIndustry special research and investment prospect investigation and Analysis Report

　　The pump should be divided into two aspects: electricity and machinery. As for machinery, you can compare the previous maintenance records. The second is electricity. You should know the power of each pump motor and have a certain understanding of its control system. Slurry pump with mechanical seal　　Water or air leakage in the pipeline. The nut may not be tightened during installation. If the leakage is not serious, the air or water leakage can be treated with cement or cement slurry mixed with asphalt oil. Temporary repairs can be done with some wet mud or soft soap. If water leaks at the water pump joint, tighten the nut with a wrench. asGhazi Abad ,　　Friends who are more concerned about this issue can dispel their concerns.　　 one method is to use ultrasonic method to detect whether the equipment has cavitation. This method is often convenient for re detection. Even if there is some noise in the surrounding environment, it will not affect the detection results. Therefore, many pumps tend to have better measurement results when in use.Agogo,　　Strong strength and other advantages. It is widely used as a sealing device for various pumps. Place a water seal ring at the bottom of the packing box, and then place the filler.　　Moreover, because the length of the long shaft is generally fixed, when it is used later the place where it operates will also be limited. If the equipment will　　Is called cavitation phenomenon.

　　In the application of pumps, the first thing we think of is water. Whether it is drinking water or coefficient water,Ghazi Abad Vertical non clogging sewage pump, even the polluted water in cities needs to be purified. All these require its equipment to provide services for us. Without pumps, our basic survival is a problem.　　The rotating parts of the water pump are loose and damaged.　　There are differences.investment,　　Many people do not know much about the packing and sealing of equipment because of the equipment of mass and energy. Next, let&#;s learn about the packaging and sealing method of the equipment: packing sealing is very common in submersible slurry pumps. This method has good sealing performance, is easy to use, and effectively reduces the wear of the host and anti vibration kinetic energy　　There are differences.　　 drainage and water injection with vacuum equipment: the self exhaust of centrifugal pump is the same as the negative pressure exhaust of vacuum pump, so the water ring vacuum pump is used for exhaust to achieve the of water inlet.

　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.The cheapest,　　If there is a standby pump, it is better to use two pumps in turn. If the pump is stuck,Ghazi Abad Single stage slurry pump, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!　　Tighten the terminal blocks.　　 First of all, we need to choose equipment with formal certificates when making choices. We must avoid buying some obsolete or inferior products. And sometimes when the pump is in use multiple pumps need to be used in parallel or standby pumps need to be prepared.Ghazi Abad ,Ghazi Abad Vertical heavy-duty slurry pump,　　Vertical slurry pump is an early product. Submersible slurry pump is a new product developed with the improvement of social demand and operating environment.　　How to disassemble the submersible slurry pump and how to assemble it after disassembly. The technical points and precautions for disassembly will be introduced to avoid disassembly, pump damage and disassembly.　　When using the sand pump, run the pump without load. Check whether the motor operates normally. During operation, be careful not to exceed the bearing on the pump support to avoid