BakersfieldLeishnoWhat are the key points of the control method

Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of meters by meters.Bakersfield,The pressure joint between the pipe joint and the rubber hose fails prematurely, causing oil leakage or pipe explosion. The oil temperature rises due to frequent action of the overflow valve.The quality of the standard section should comply with the product manual and specification requirements.Narayanganje,Setting requirements: The installation and dismantling workers,BakersfieldEmen, electricians, and other operators of construction electric elevators should have special construction operations.Small safe operation distance: Circuit voltage (kV) of external power lines<~~~ Small safe operation distance (m) Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.The landing door should meet the requirements of the specifications and achieve standardization.

The counterweight guide rail should meet the specification requirements.Do not move after lifting,BakersfieldDarmstadt, and do not lift until the four legs are firmly supported.Then, the lifting platform platform platform that carries the load needs to be balanced and no deviation of one side is allowed. The lifting of goods does not allow people to stand on both sides of the platform, and the lifting of goods should try to maintain a stable and uniform speed.How much does it cost?,Setting requirements: For construction electric elevators with foundations installed on roof slabs, or other lower suspended structures, the door may not meet the above requirements, but safety should be maintained.When a rigid mm square or circular flat surface is applied with a normal force of N to either side of the door, the door may not meet the above requirements, but safety should be maintained.

The verticality of the guide rail frame should meet the requirements of the specifications.Create brilliance,The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.There is a certain itinerary.The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.Bakersfield,From the above comparison it can be seen that hydraulic electric lifting mechanisms have stable lifting, low noise, long service life,BakersfieldLi Shi, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.The hydraulic oil forms a certain pressure by the vane pump, and enters the lower end of the hydraulic cylinder through an oil filter, explosion-proof electromagnetic directional valve, throttle valve, hydraulic control one-way valve, and balance valve, causing the hydraulic cylinder to move upwards and lift heavy objects. The return oil at the upper end of the hydraulic cylinder returns to the oil tank through the explosion-proof electromagnetic directional valve, and its rated pressure overflow valve is adjusted. The pressure gauge observes the reading value on the pressure gauge. The downward movement of the hydraulic cylinder (i.e. lowering of heavy objects).