Zutphen Electric hydraulic folding elevatorIncentive quality measures

Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.The verticality of the guide rail frame should meet the requirements of the specifications.Zutphen ,High altitude operations and maintenance in areas such as repair,Zutphen Electric guide rail elevator, logistics, electricity, transportation, petroleum chemical, hotel, sports center, mining, also known as hydraulic liftingThe entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side, and the door bolt must be set on the side next to the construction electric elevator.SultanbeyliDouble layer steel mesh: The diameter of the steel bars is mm, with a spacing of mm.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.Use floor doors and cage door devices on construction sites where conditions permit.

Mechanical devices controlled by cage movement should not be used to open or close the landing door.The coaxiality between the motor shaft and the worm shaft in the aluminum alloy electric elevator drive device should be less than .mm, and there should be a mm gap at the shaft end to ensure that the motor bearings bear reasonable loads and reduce motor operating noise; electricThe pump body adopts an integrated pump station, all equipped with imported high-quality pump stations,Zutphen Self propelled electric elevator, which can also be selected according to customer requirements to meet customer ideal requirements.Free consultation,According to the needs of different performance genres, the form of the stage can be changed. For example, using an orchestra pit lift can combine a framed stage with a large lip or even an extended stage. In an experimental theater, using a lift can make the theater have various forms such as an end stage, an extended stage, an island stage, an intermediate stage, a T-shaped stage, or a hall.The hydraulic oil enters the upper end of the hydraulic cylinder through the explosion-proof electromagnetic directional valve,Zutphen Mobile, and the return oil from the lower end of the hydraulic cylinder returns to the oil tank through the balance valve, hydraulic control one-way valve, throttle valve, and explosion-proof electromagnetic directional valve. To ensure a smooth descent of heavy objects and safe and reliable braking, so that the descent speed does not change due to heavy objects. The throttle valve regulates the flow rate and the ascending and descending speed.When the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.

Setting requirements: For construction electric elevators with foundations installed on roof slabs, floors, or other lower suspended structures, the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.Application process,Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).Electric elevators should be regularly maintained and cleaned. During maintenance and cleaning, the bracket should be supported to prevent the electric elevator from overturning. Electrical and hydraulic systems should be maintained by professional personnel; When the battery level display is less than %The use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets, etc.Zutphen ,The quality of the standard section should comply with the product manual and specification requirements.Small safe operation distance: Circuit voltage (kV) of external power lines<~~~ Small safe operation distance (m) Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.When the wall bracket adopts non matching standard products design calculations should be carried out.