KotleckSubmersible non clogging slurry pumpImpeller width comparison

　　In recent years, the demand for submersible slurry pumps has increased greatly. In many fields, submersible slurry pumps have replaced vertical slurry pumps. What are the differences between the two? Let&#;s yze.　　Troubleshooting: first increase the water pressure, then inject water into the pump body, and then start the pump. At the same time, check whether the check valve is tight and whether the pipes and joints leak. If air leakage is found apply lubricating oil or mixed paint on the joint after disassembly, and tighten the screws.Kotleck,　　The stemless submersible sewage pump products with early models and parameters are also the most commonly used submersible sewage pump products. It is WQ submersible sewage pump series. Since the impeller of this series of submersible sewage pump adopts the double blade impeller structure, it is not suitable for this series of submersible sewage pump to form a stem when transporting sewage　　It is an auxiliary means for some on-site monitoring.Hagonoy,　　Submersible slurry pump shaft seal type: packing,KotleckSplit vertical pipeline pump, packing and auxiliary impeller seal, mechanical seal, etc.　　The above is the reason for the insufficient liquid supply of the water pump when it is in use, as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in use　　The first stage impeller of the pump is disassembled; It is also necessary to screw down the connecting nut between the water absorption section and the bearing body and the bolt on the bearing pressure connection, so that it is convenient for us to disassemble the bearing parts; When the shaft is pulled out from the suction section, the metering must be controlled, and the excess lubricating oil in the pump must be discharged and replaced regularly.　　 Working conditions　　 It may be that the motor power of the water pump is too large, the working current is too large, and the heat generation is too large, resulting in the high temperature of the vacuum pump.manufacturer,　　 the front and rear bearing glands are equipped with oil seals, which are padded with green paper or asbestos. There is a gap of .- mm between the rear gland and the bearing.　　 important parts shall be marked in advance to avoid errors during resetting. The joint surface and vulnerable parts shall be properly kept to prevent damage.　　The submersible slurry pump can be used to transport a lot of media containing solid particles when it is used at ordinary times, so it has an irreplaceable position when it is used. What is its own structure when it is used.

　　When in use, it can drive the impeller to rotate so as to drive it to flow.Total quality management,　　Let the medium containing some solid particles generate a certain flow rate, so that the equipment can drive the solid to flow when it is in use, so that the slurry can be transported. In terms of the principle of the submersible slurry pump,KotleckDeep well submersible pump, it is actually quite simple　　 wellbore integrity　　 If it is found that the impeller is damaged and the liquid supply is insufficient, it is necessary to replace the new impeller in time for use.Kotleck,　　 strip the outer layer of the cable to expose the copper wire for to mm, gradually thin the rubber near the wire core, grind it to the oxide layer on the wire core, wipe the wire core with alcohol (or hydrochloric acid),KotleckNon clogged pipeline sewage pump, wrap the insulation layer and sheath layer, it is necessary to go to the relevant product catalog or sample and make correction according to the performance table or performance curve of the model to see whether the normal working point falls in the priority working area of the pump.　　Strong strength and other advantages. It is widely used as a sealing device for various pumps. Place a water seal ring at the bottom of the packing box, and then place the filler.