Boden townWQ submersible sewage pumpIf you don’t take good care of it, something will happen

　　Extend service life. In fact, the submersible slurry pump is widely used in many lives, which can separate the pump body from the motor, so it mainly plays a role in use　　When in use, it can drive the impeller to rotate so as to drive it to flow.Boden town,　　 within the estimated installation depth, the minimum inner diameter of the well is mm　　Start the priming pump. Moreover, due to the structural limitations of the submersible slurry pump, the motor needs to be placed on the water surface for use during operation, and then the pump needs to be placed in the water for use. Therefore, the submersible slurry pump must beShakiso　　In the mud pump, the axial force is mainly composed of the pressure difference force of the liquid effect on the impeller and the gravity of the whole rolling part. The effect direction of the two forces is the same, and the resultant force is the sum of the two forces. If the submersible slurry pump is equipped with an auxiliary impeller, the liquid effect is on the auxiliary impeller　　 When starting the slurry pump, expand the pump inlet valve and close the pump outlet valve. Then start the pump. After the pump is started, slowly start the pump outlet valve. The size and speed of opening the pump outlet valve should be based on the fact that the pump does not vibrate and the motor　　 drainage and water injection with vacuum equipment: the self exhaust of centrifugal pump is the same as the negative pressure exhaust of vacuum pump, so the water ring vacuum pump is used for exhaust to achieve the of water inlet.

　　It is an auxiliary means for some on-site monitoring.recommend,　　Submersible slurry pump In addition, the sewage pump is usually driven by a motor,Boden townSubmersible pump can pump sewage, which also requires some time og quantity when switching on and off, so in fact, it can be adjusted to a certain extent during use. The submersible slurry pump needs to use a line when in use　　 Take out the locking ring of the coupling, unscrew the fixing screw and remove the connecting bolt to separate the motor and water pump.　　During normal operation, the temperature of the motor is very high, some even as high as ℃. In this case, it is easy to burn the motor and replace it with a new one. In fact, orBoden town,　　 When adding lubricating oil to the pump at ordinary times, the metering must be controlled, and the excess lubricating oil in the pump must be discharged and replaced regularly.　　Schematic diagram of vertical slurry pump II. Why does the demand for submersible slurry pump increase greatly? From the perspective of market demand, although the absolute number of submersible slurry pumps has not exceeded that of vertical slurry pumps it has a rapid development momentum, mainly due to the convenience and flexibility mentioned above; In addition, for submersible slurry pump　　 install the front pump shaft first and then the rear bearing for the slurry pump of the filter press of the cylindrical bearing box.