KagoshimaScrew deep well pumpRecommendation consultation

　　According to the user&#;s requirements, the motor can add a variety of protection devices such as water inflow detection and overheating, so that the product can operate safely for a long time under adverse working conditions.　　Some impurities will entangle the impeller,KagoshimaSmall deep well pump,KagoshimaCarbon steel explosion-proof pipeline pump, so generally, the open impeller will be used, so there is no need to worry about getting stuck in the process of transporting sewage.Kagoshima,　　Submersible slurry pump Absorb silt and sand from rivers, lakes, oceans, reservoirs, the correct operating procedures must be strictly followed. Only the correct operating steps can make the product play an effective role in the use site.Toumodi,　　In this way, a smooth surface can be formed on the surface.　　 If the power cord is not well contacted, it will also lead to the burning of the motor.　　 fold the three layers in half with self-adhesive butyl tape and gradually extend to the outside of the core. When winding, the tape shall be stretched twice, and then the three layers shall be folded in half with PVC tape to ensure that the winding part is not less than mm, and the positions of the three joints shall be staggered for a certain distance in order to prevent short circuit.

　　What is the cause of pump overload.　　 Check the surrounding environment: when the ambient temperature is higher than ℃, resulting in overheating of the motor. Try to improve the working environment. Such as setting up shade sheds for shading.　　Vertical slurry pump is an early product. Submersible slurry pump is a new product developed with the improvement of social demand and operating environment.Quality management,　　Potential energy, pumping water up high. However, once the pump can not absorb water,KagoshimaVortex pump and pipeline pump, the equipment is shaped like a decoration, so what is the reason for this situation? How to solve it?　　It, generator and market formed at the beginning of construction have gradually formed a certain scale after more than ten years of rapid development. In the early stage, in order to meet the needs of market development, generators and other mechanical and electrical products were collectively moved to the phase II market for operation. With a good business environment, water pumps and generators　　With the continuous development of slurry pump technology, this type of pump is especially suitable for the depth where the vertical slurry pump cannot operate. Pay attention when using the equipment. The submersible slurry pump can operate if its depth is less than m, but it exceeds

　　Extend service life. In fact, the submersible slurry pump is widely used in many lives, and there is a very important component water seal in the pump which can separate the pump body from the motor, so it mainly plays a role in useHow much does it cost?,　　Balance of.　　Wheel wear is too serious; The water absorption can not reach or exceed the specified height: it may not be the problem of the pump itself, but the local water volume is too small.　　The operating environment is different: the key difference between the submersible slurry pump and the vertical slurry pump lies in diving. During the operation of the vertical slurry pump, some parts intrude into the pit and cannot completely invade the slurry; The submersible slurry pump can completely penetrate below the slurry level.Kagoshima,　　The above is the reason for the insufficient liquid supply of the water pump when it is in use as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in use　　The submersible slurry pump can be used to transport a lot of media containing solid particles when it is used at ordinary times, it must be used continuously during transportation. If there is an interval in the middle so it has an irreplaceable position when it is used. What is its own structure when it is used.　　Submersible slurry pump In addition, it must be avoided that the interval is relatively long, so as to avoid the solidification of slurry in the pump when the operation is stopped.