TikritVortex pump and pipeline pumpWiring construction process

　　Water flow into the bearing damages the bearing.　　Balance of.Tikrit, in fact we choose to use larger flow. Let&#;s take a look at the method of selecting pumps.Chust,　　 If the pump is equipped with a vacuum gauge or pressure gauge, close the cock connected with the submersible slurry pump before starting the motor, open it after the speed is normal,TikritQJ submersible pump, and then gradually open the outlet sluice valve. If the flow is too large, you can properly turn down the gate valve for adjustment. Otherwise, if the flow is too small,Open the gate valve.　　There will be no insufficient liquid supply or other problems.　　Strong strength and other advantages. It is widely used as a sealing device for various pumps. Place a water seal ring at the bottom of the packing box, and then place the filler.

　　 When stopping the operation of the submersible slurry pump, close the cock of the vacuum gauge and pressure gauge and the gate valve on the water outlet pipeline, and After that, cut off the power supply of the motor. If the temperature of the environment is low, open the square plug at the lower part of the pump body to remove the remaining water to avoid frost cracking. During operation, the maximum temperature of the bearing shall not exceed ℃, and the quantity of calcium base grease used for lubricating oil bearing shall be the same as that of the bearing body　　It can help you to use the self-priming pump.　　 The standby submersible slurry pump shall roll the shaft / turn every week to make the bearing uniformly accept the static load and external oscillation. The building structure in the water pump room shall be reconstructed. Sound absorbing and isolating plates shall be installed around the wall and on the top of the machine room and fixed with light steel keel; The connecting holes between the machine room and other rooms are tightly blockedHow much does it cost?,　　Submersible slurry pump In addition, it must be avoided that the interval is relatively long, so as to avoid the solidification of slurry in the pump when the operation is stopped.　　The fruit is also bad; When the axial flow pump is used, its water output is relatively large, but the head is not too high, so the effect of using the submersible slurry pump in many plain areas is also relatively good; The water output and head of the mixed flow pump are actually derived from one　　It needs to be replaced in case of damage, swelling and deformation, insufficient spring pressure, breakage, etc.

　　 repair and level the welding part of the submersible slurry pump with a file, clean the part to be bound with alcohol again and wipe it dry.Total quality assurance,　　Therefore, the stator winding will be burnt out due to excessive temperature rise.　　 absorb various solid slurry products processed by various coal water slurry operations.　　 Impeller protection in order to ensure the operation of the submersible slurry pump, it is necessary to timely adjust the clearance between the impeller and the front guard plate. When adjusting the impeller clearance,TikritQuotation slurry pump, first stop the pump, loosen the bolts pressing the bearing box,TikritHorizontal non clogging sewage pump, loosen the adjusting nuts, make the bearing components move forward, and roll the shaft by hand to press theTikrit, lift the submersible slurry pump and move it to the adjacent position of the previous sand pumping place to continue pumping sand, so as to move the sand pumping place back and forth for sand pumping, so that the sand pumping area in this area forms a honeycomb,　　 Inspection before installation: Check the specification, size and quality of thick and thin accessories.　　Moreover, the leaked flammable, explosive and toxic liquid will cause fire, explosion and poisoning, and the consequences will be unimaginable.