SanMarcosHow about laminate floor cleaningIndustry leader

SPC floor is an economical floor material. Consumers can enjoy the texture of wood grain or stone grain in use without being bothered by noise.According to the requirements of consumers for sound insulation, blocks, plates or coils can be selected.Floor lacquer cloth, also known as floor leather (not PVC plastic floor), is a kind of paving material. It belongs to rubber plastic products. It is one of the indispensable floor materials for the decoration of power distribution room, the size of the product is determined according to the space of the house and the size of the place of use.At the same time, pay attention to the different places of use, and the selected patterns should also be different.For example, in places that need to be kept clean you can&#;t choose products with convex effect;In solemn places, it is not suitable to choose products with bright colors and messy.The width of coiled floor paint cloth is mm, mm and mm;The total thickness (referring to the base material, intermediate layer and surface wear-resistant layer) is divided into mm and mm;The length of each roll of floor leather is m and m.Other specifications and dimensions can be determined by the supplier and the buyer through negotiation.Because of the requirements of production each roll of floor paint cloth is divided into several sections (the patterns between each two sections are misplaced), so the length of the small section of a roll of floor paint cloth with sections shall be indicated, and the length of the roll of floor paint cloth shall be increased by at least cm (i.e. not less than two complete patterns).Generally, there can only be one section for high-quality products and the number of sections of each volume of first-class products and qualified products shall not exceed ;The length of each section of first-class products shall not be less than m, and the length of each section of qualified products shall not be less than m.When inspecting the appearance quality of floor paint cloth leather, observe whether there are cracks, fractures and delaminations on the surface of the floor leather. If so, it can be determined that the floor leather is unqualified.The second step is to observe whether there are wrinkle marks, bubble pollution points and pattern deformation. What cannot be observed are excellent products and first-class products;If it is slight but not obvious, it is deemed as qualified. Go back to the third step to observe whether there are missing patterns on the surface of the floor leather and whether there are defects of the transparent wear-resistant film on the surface. If there is no, it is the first-class product and the first-class product. If there is slight missing or lack of film, it is the qualified product, otherwise it is the unqualified product.Finally, carefully check whether there is deviation during multi-color overprint on the surface, whether there are color differences in different parts, whether the superior products are uneven, and if there are the above two defects, the first-class products are those with but not obvious and the products with obvious above defects but do not affect the overall beauty are determined as qualified products.Finally, based on the above judgment, the appearance quality of ground lacquer cloth is determined.The plastic coil floor paint cloth shall roll the wear-resistant layer outward on the pipe core and shall be externally packaged.The product name, manufacturer name, product mark, grade, batch number, quality and length shall be marked at the obvious place of each package.In addition to the above three items that can be directly judged by the senses, attention should also be paid to the physical properties when purchasing floor leather to ensure its service life.Main differences between WPC and SPC flooringSanMarcos, The difference between composite floor and solid wood floor. The conventional thickness is only -mm. The ultra-thin design is a bold innovation in the professional industry. The surface is printed with materials to improve the service life of people flow field. The surface imitates the real wood texture and natural marble texture. In view of the characteristics of raw materials, it has fast heat conduction and long heat storage duration. It is the preferred floor for floor heating.Urgut, which is often made of pine, fir and other softwood. Ultra light and ultra-thinWhen asked about the service life and wear resistance of SPC floor in the message area of the message board, it is often mentioned to take out artifact such as fruit knife or key and scratch on the surface of SPC floor. If there are scratches, they are classified as non wear resistance.In fact, the national wear resistance test of PVC latch floor is not simply to scratch on the surface with artifact, but to grind and polish the floor with thick bottom circular stone roller under the condition of kg charging. After how many revolutions of rotation and polishing, the wear-resistant layer on the floor surface is damaged and exposed to the speed of rural grass-roots.The rotational speed of this connection point is an index value considering the wear resistance of PVC latch floor.For example, the minimum speed of national composite floor is rpm.Therefore, the wear resistance of PVC latch floor is professionally measured by the national testing center.

Domestic cheap decorative paper is usually used. The pattern of this decorative paper is fuzzy. The biggest defect is that it is generally not UV resistant and will fade after sunlight.This is why some consumers reflect the discoloration of the places near the balcony and windows three or four months after the floor is installed. The base material is poor,SanMarcosComposite waterproof board price, medium and low density board or particleboard is used, the quality index is unstable, and the formaldehyde seriously exceeds the standard.Fear of water and moisture: the base material of laminate floor is medium and high density board, with small relative density and large expansion coefficient. Once the reinforcing layer is filled with water after paving, if it is not wiped in time, it is easy to cause blistering and deformation due to water absorption and expansion. Its moisture resistance is not strong, and its stability is poor in humid environment.In order to prevent local fading due to frequent sunlight exposure,SanMarcosFloor antiskid, it is best to hang curtains to turn direct light into diffuse light, which is conducive to prolonging the service life of the floor. Pay attention to the fact that hard substances such as metal sharps and shoe staples are easy to scratch the surface of the worn lacquer cloth. Avoid cigarette butts, boiled water and hot objects above ℃ from directly contacting the plate surface. Prevent burning marks and scalding marks. Do not press the surface with rubber pads for a long time,In case of indentation, it is difficult to remove. Although the ground lacquer cloth is flame-retardant and self extinguishing, it will decompose harmful gases at high temperature, which will suffocate if inhaled too much. First,SanMarcosOK, what are the brands of wood flooring, pursue foreign goodsProduct line,The general specification and model of general floor is cm×cm, the specification and model of high-capacity floor can reach cm×cm, with a total area of times that of the general wooden floor.The floor is generally made of common materials such as red sandalwood and Huanghua pear wood. The corner material is discarded and made of a key part of the whole tree. It mainly shows the air. The road construction has an endless sense of flexion and extension and three-dimensional feeling. Prevent the floor from being deformed by cooking utensils.Physical and mental health floor is the floor produced according to the production and manufacturing product quality standards and installation and application testing standards (double specifications), which is not easy to cause harmful substances and ensure the health and safety of residential gas.

Whether to renovate the board.Quality documents, Products of well-known brand manufacturers with business history are preferredSolid wood flooring： I can&#;t tell the taste. The domestic price of this floor is more than yuan;SanMarcos, and there is no obvious color difference on both sides.Medium and low grade solid wood floors indicate that cracks may occur.If the crack is not a problem between textures, there will be some hidden dangers if the crack passes through the texture.The surface is treated with special technology, without air holes and water impermeability. It is no problem to shop in the areas where toilets and kitchens communicate with water.No, it will deform and bubble, or it will become moldy due to high humidity.