ministerEvlerWhat are the advantages in the protection industry

Speed limiter. To prevent the driving speed from exceeding the normal speed. A speedometer should be installed (not required for floors below or including the second floor), which is an individual mechanism that is integrated with a safety clamp; The entrance and exit of the passenger compartment should be equipped with safety doors. Public places, family dormitories, andSpeed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.minister,Safety devices: Electric elevators for construction should be equipped with overload detection devices. When the load inside the cage exceeds % of the rated load capacity, the overload detection device will give a warning signal inside the cage,Low power consumption: When the hydraulic guide rail lifting platform descends, it is driven by the pressure generated by its own weight, greatly saving energy and reducing consumption.Adiwerna,Setting requirements: The wall bracket should use the manufacturer's matching standard products.The motor of the hydraulic guide rail lifting platform is set around the wellbore, improving the utilization rate of the wellbore area.Civil engineering advantages: The pit depth of the guide rail type lifting platform is generally around -mm, and the top layer is not affected. It can be customized according to the location and environment.

The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.The inner bearing of the roller in the device is in good condition,ministerLos Angeles, and a complete grease film surface is maintained between the curved surface of the roller and the main chord of the aluminum alloy electric elevator. A good grease film surface can reduce wear and noiseSetting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.how much,The setting of the cable guide frame should comply with the user manual and regulatory requirements.The quality of the standard section should comply with the product manual and specification requirements.Civil engineering advantages: The pit depth of the guide rail type lifting platform is generally around -mm, and the top layer is not affected. It can be customized according to the location and environment.

Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).A complete range of products,Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.When adding hydraulic oil, we can extend the oil cylinder to the high position for filling. When filling, the lifting platform should not exceed the high position, and then retract the oil cylinder back to the low position to check if the hydraulic oil level is lower than the low position, it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness, strength, stability,ministerShuozhou, etc., and the production should meet the design requirements.minister,Secondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered to times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space and ensure that the lifting platform can be lifted to the rated lifting height.Acceptance: Concrete strength grade C, strength testing report.Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.