FujisawaVertical multistage centrifugal pipeline pumpLarge stock

　　There are differences.　　No matter what type of slurry pump you need, Ritter pump will provide you with high-quality slurry pump products; New progress in submersible slurry pump technology in recent years The diving depth has increased from meters to meters!Fujisawa,　　Compared with the investment in purchasing cf fire control cabinet, the maintenance cost saved is considerable.　　During adjustment, firstly loosen the support cover, then compress the nut, and then loosen the bearing seat. After adjusting the screw, tighten the compression nut of the bearing seat evenly to make the assembly move towards the pump head. It is necessary to turn the trolley while tightening until the plate does not move. Rotate according to the pump operationMutenz,　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.　　The water slurry pump is a widely used equipment. Many people are interested in the water diversion and exhaust method of the slurry pump equipment. Now let&#;s talk about the water diversion and exhaust method of the submersible slurry pump: the submersible slurry pump needs to pump out the water to form a vacuum, and then supply water,　　 First, and then remove the nuts used for the connection between the three parts: discharge section, stuffing box body and bearing body; Then screw off the round nut on the shaft, and successively install the bearing inner race, bearing gland and retaining sleeve

　　 The slurry pump mainly aims at conveying flow, so the flow meter (meter) shall be installed in the operation monitoring system as far as possible to monitor whether the flow meets the requirements at any time; In the pipeline system, slag flushing system and pressure filtration dehydration system equipped with hydrocyclone, certain　　 No leakage protector is installed: leakage protector is also known as lifesaver. If the leakage value of the submersible sewage pump is higher than the working current value of the leakage preventer, the leakage preventer will cut off the power supply of the submersible pump to ensure the normal operation of the equipment.　　Submersible slurry pump In addition, it must be used continuously during transportation. If there is an interval in the middle, it must be avoided that the interval is relatively long, so as to avoid the solidification of slurry in the pump when the operation is stopped.Finance Department,　　 in addition the noise method directly detects the noise of the equipment in the detection process, but such measurement will also be affected by the surrounding noise, so in fact, such measurement is not very accurate.　　Carbon,FujisawaHH slurry pump, building materials,FujisawaSubmersible slurry pump, chemical industry and other industrial industries are mainly used to transport abrasive pastes containing solid particles.　　When using the sand pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation, be careful not to exceed the bearing on the pump support to avoid

　　Water or air leakage in the pipeline. The nut may not be tightened during installation. If the leakage is not serious, the air or water leakage can be treated with cement or cement slurry mixed with asphalt oil. Temporary repairs can be done with some wet mud or soft soap. If water leaks at the water pump joint, tighten the nut with a wrench. asInspection environment, remove the impellers, middle sections and guide vanes at other levels in the same way until the submerged slag slurry　　Correct the main shaft of the water pump and adjust the position of the water pump and the motor relatively.　　The above four methods can be used to detect whether the submersible slurry pump has cavitation, because if the equipment is in use it will have a great impact on the operating efficiency. Even if the cavitation time is long, it will also have a certain impact on other parts of the equipment. Sometimes submersible slurry pumpFujisawa,　　Do not exceed the rated current.　　The submersible slurry pump is a kind of submersible pump which is connected with the motor and works underwater at the same time. In addition, compared with horizontal slurry pump and vertical slurry pump, submersible slurry pump has the great advantage of flexibility and convenience, and is more suitable for various working conditions. The important technical points of submersible slurry pump are its motor and　　 In addition,FujisawaAh slurry pump, the noise method directly detects the noise of the equipment in the detection process, but this measurement will also be affected by the surrounding noise so in fact, this measurement is not very accurate.