da tong3 ton hydraulic lifting platformType of choice

The electromagnetic coil of the electromagnetic directional valve is not firmly fixed, and frequent separation and suction can also produce high noise.When the hydraulic oil of the equipment is insufficient, it will not cause lifting. At this point, you only need to add enough hydraulic oil to run.da tong,Usage and instructions for steel wire ropes in elevators: The steel wire ropes of the steel wire ropes require very high strength, usually made of high-quality carbon steel with a carbon content of .% -.%. They are widely used as transmission components in elevators. Due to its large load-bearing capacity, light weight, no noise, suitable for high-speed transmission, high strength, strong overload capacity and reliable operation, it has become a commonly used rope for hydraulic elevators.This paper briefly introduces some matters needing attention in the selection of oil tank for hydraulic elevators. The main functions of the hydraulic oil tank for elevators in the hydraulic system of elevators and hydraulic elevators and other hydraulic machinery are oil storage, heat dissipation, separation of air contained in oil and elimination of foam.Guayaquil,Motor not running: Check all components of the motor for damage and check if there are any problems with the circuit and wiring.Next, the hydraulic cargo elevator manufacturer will explain the maintenance of the mechanical equipment of the elevator: the brakes of each organization should be frequently checked and adjusted to ensure the clearance between the brake pads and wheels is sensitive and reliable. On the surface, there should be no dirt present. If there is dirt, it is necessary to wash it off with gasoline or thinner.Solution: Check if the performance of the legs is good, even if the butter is polished to increase its properties.

When using hydraulic elevators, the main causes of noise are mechanical mechanism failures, hydraulic system failures, electrical equipment or component failures, etc. Today, the manufacturer of hydraulic cargo elevators will introduce to you the reasons for the noise generated by hydraulic elevators.It is not allowed to throw tools and materials up and down, and ropes should be used to tie or hang them to avoid injuring workers or scaffolding below.Before installation, the installation personnel should confirm the infrastructure such as the foundation and shaft,da tongHousehold elevator, pay attention to alignment, leveling, and alignment points, and confirm that the foundation meets the requirements before construction.Online consultation,The main device does not engage. When this fault occurs, check whether the three-phase power supply is normal, the electric lock switch are turned on, whether the three-phase electrical phase sequence is correct,da tongGuide rail elevator, and whether the relay working indicator light is on.Remove the hydraulic oil tank filler cap, filter cover, inspection hole, hydraulic oil pipe and other parts to avoid dust when removing the system oil pipe. Clean the disassembled parts before opening them. When disassembling the hydraulic oil tank filler cap, first remove the soil around the tank cap, loosen the tank cap, and remove any remaining debris from the joint (do not rinse with water to prevent water from seeping into the tank). After confirming cleaning, open the tank cap.The main device does not engage. When this fault occurs, check whether the three-phase power supply is normal whether the internal and external emergency stop button switches, the electric lock switch are turned on, whether the three-phase electrical phase sequence is correct, and whether the relay working indicator light is on.

What are the methods for reducing shaking on lifting platforms? Reducing the shaking of the lifting platform can reduce the psychological obstacles of the operators, ensure the smooth progress of the operation,da tongMast type aluminum alloy hydraulic lifting platform, and also greatly help improve safety. Warm reminder: safety, do not operate blindly. Lifts are widely used in many places, and their working principles vary. Today, we will analyze the working principles of elevators. The types of elevators are generally divided into the following: fixed elevators, This type of elevator uses hydraulic oil cylinders and pump stations to transmit power, in the form of a scissor fork type. According to customer requirements, the length of the support rod for the scissor fork, the number of layers, the angle of the angle axis and the expansion and contraction of the oil cylinder complete the lifting operation. Its advantages are large load-bearing capacity, stable lifting, and high safety.new product, carry out medium maintenance on the mechanical and electrical systems.What are the requirements for the pit? This type of cargo elevator only needs - centimeters and does not require too much space. The installation of scissor type hydraulic cargo elevators is different from that of guide rail type hydraulic cargo elevators. The scissor lift cargo elevator has a large load-bearing capacity, and the pit depth needs to be set at around - centimeters. It can also be designed according to customer on-site needs.When the hydraulic lifting platform is working, the load cannot exceed its rated load. When it is raised to a certain height the larger the mass of the object, the greater the shakingda tong,After hours of elevator operation