MaceAarhus Recent industry trends

Protective measures should comply with regulatory requirements.When the foundation is set on the roof or floor structure the bearing capacity of its supporting structure should be checked.Mace,Construction electric elevators must be equipped with lifting cages and reusable buffers, and comply with regulatory requirements.Monthly maintenance and inspection of hydraulic lifting platform rollers, intermediate shafts and bearings,MacePesack, oil cylinder pin shafts and bearings, boom hinge shafts and bearings for wear. Add some oil to each part to extend the service life of the lifting platform bearings. The quality and level of hydraulic oil. The lifting platform should be raised throughout the entire process, and at this position, the hydraulic ground should be - millimeters higher than the bottom of the box. If the hydraulic oil becomes dark, sticky, or has foreign objects such as gravel, it should be replaced in a timely manner ( # hydraulic oil). Annual maintenance and inspection of all hydraulic pipelines and joints of the lifting platform. The pipeline must not be damaged, and the joints must not be loose. All joints must be tightened. Remove and disassemble the lowering valve of the lifting platform,MaceTeveso, blow out the plunger with compressed air, then install it and reinstall it. Drain and discard the hydraulic oil, tighten the joint, remove the oil filter, clean it with compressed air and then return it to the oil tank and connect the pipeline.Maharagama, it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness, strength, stability, etc., and the production should meet the design requirements.The scaffolding of the parking platform should be laid tightly and firmly.When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.

Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).When a suspension cage with a rated load capacity acts on the buffer at a speed greater than the rated speed of .m/s, the average deceleration of the suspension cage should not exceed g, and the time when the peak deceleration exceeds g should not exceedThe advantages and disadvantages of several commonly used electric lifting mechanisms are as follows: hydraulic electric lifting mechanisms: using hydraulic technology,Installation and dismantling personnel and drivers should hold certificates to work.When the wall bracket adopts non matching standard products, design calculations should be carried out.The use of standard section connecting bolts should comply with the user manual and specification requirements.

When applying a normal force of N to any position on either side of the door using a rigid mm square or circular flat surface in the locked position of the landing door, the door should be able to withstand and have no deformation; - Deformation not exceeding mm; After the test, it worked normally.Scheme customization,The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.Setting requirements: Buffers should be installed below the suspension cage and counterweight running channel.The verticality of the guide rail frame should meet the requirements of the specifications.Mace,Before operating the construction electric elevator, routine inspections should be carried out according to regulations and inspection records should be filled out.Speed limiter. To prevent the driving speed from exceeding the normal speed. A speedometer should be installed (not required for floors below or including the second floor), which is an individual mechanism that is integrated with a safety clamp; The entrance and exit of the passenger compartment should be equipped with safety doors. Public places, family dormitories, andHorizontal lead screw mechanical electricity