Saguenay Submersible non clogging slurry pumpFrequently asked questions

　　Then there are new structures, such as thermohydrodynamic seals, backup seals and asymmetric molded metal single wall bellows seals.　　Yes, summer is the peak sales season. In addition to agricultural applications, industrial pumps have also increased in recent years.Saguenay ,　　Submersible pump: as the name suggests, the whole pump (with motor) needs to be in the slurry.　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.Salian,　　 bind the exposed copper wire to the cable core evenly heat it with an electric iron, and infiltrate tin evenly.　　 One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump, and use the PID adjustment of the frequency converter. When　　 the front and rear bearing glands are equipped with oil seals, which are padded with green paper or asbestos. There is a gap of .- mm between the rear gland and the bearing.

　　How to avoid this situation when the equipment is in use.　　Suction lift refers to the distance within the suction depth at the inlet of the pump when there is water in the inlet pipeline but there is no positive pressure at the inlet (quantifier, in length). In fact, all centrifugal pumps have suction head, but the length is different. In a word, those with higher head have suction head　　Rotate in the rolling direction until the friction between the impeller and the front guard plate stops, then use the adjusting bolt to move the rotor backward, record the forward and backward movement gap, evenly distribute it between the front and rear guard plates of the impeller until the gap between the impeller, the front guard plate and the rear guard plate is flat, stop,　　Submersible slurry pumps are mainly used in mining, metallurgy, coal, environmental protection, electric power and other industries to transport corrosive solid particle slurry. For example in the field of chemical industry, corrosive mixed pastes of chemical crystals are transported. Electric ash removal,Saguenay Used pipeline pump, coal washing plant slurry transportation, etc. Submersible slurry pump blade　　 Move the sand pumping site frequently. When the pump pumps sand at a fixed position and drops to a certain height, lift the submersible slurry pump and move it to the adjacent position of the previous sand pumping place to continue pumping sand, so as to move the sand pumping place back and forth for sand pumping, so that the sand pumping area in this area forms a honeycomb,Saguenay Vertical heavy-duty slurry pump,　　Carbon, building materials, chemical industry and other industrial industries are mainly used to transport abrasive pastes containing solid particles.

　　 drainage and water injection with vacuum equipment: the self exhaust of centrifugal pump is the same as the negative pressure exhaust of vacuum pump, so the water ring vacuum pump is used for exhaust to achieve the of water inlet.Industry management,　　When the pump is not in use, the pump shall be lifted away from the water source in time to drain the accumulated water in the pump, especially in cold winter. Then put it in a dry place. Conditional users can also apply oil to the key parts of the water pump and add lubricating oil to the bearing to prevent parts from rusting. in addition　　(d) The average maximum relative humidity in the wettest month is %. At the same time, the monthly average minimum temperature is not higher than ℃　　So it is called: submersible slurry pump.Saguenay , swelling and deformation, breakage etc.　　So it is called: submersible slurry pump.　　 selection of raw materials for flow passage parts: the raw materials for flow passage parts of the pump can be selected according to the particle composition, particle size, shape, hardness,Saguenay Pipeline pump body, concentration, acid, alkali and other characteristics of the transported materials.