NingxiaLa Rochelle On-site management method of production workshop

The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.When the landing door is closed, the full width of the lifting passage opening should be covered.Ningxia,Construction electric elevators should be equipped with emergency stop switches and comply with regulatory requirements.News Abstract: The development of the lifting platform industry will continue to grow in recent years! With the continuous development of electric lifting machinery for high-altitude operations in recent years, the products of electric lifting platform vehicles have been continuously improved, and various new technologies and materials have emerged,The L distance depends on the selected wall mount model.The L distance depends on the selected wall mount model.Setting requirements: For construction electric elevators with foundations installed on roof slabs, floors, or other lower suspended structures, the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.

The connection method and angle between the wall bracket and the building structure should comply with the requirements of the user manual.The installation position of the lower limit switch. The installation position of the lower limit switch should ensure that the contact plate triggers the switch when the rated load of the suspension cage decreases, causing the suspension cage to stop. At this time, the contact plate should also be close to the triggering of the lower limit switchSetting requirements: For construction electric elevators with foundations installed on roof slabs, floors, or other lower suspended structures, the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.Quality assuranceThe safety distance between the outer edge of the upper part of the landing door and the moving parts of the electric elevator during normal operation should not be less than .m; If the rated speed is not greater than .m/s, the safety distance can be .m.The hydraulic oil forms a certain pressure by the vane pump, and enters the lower end of the hydraulic cylinder through an oil filter, explosion-proof electromagnetic directional valve, throttle valve, hydraulic control one-way valve,NingxiaPadua, and balance valve, causing the hydraulic cylinder to move upwards and lift heavy objects. The return oil at the upper end of the hydraulic cylinder returns to the oil tank through the explosion-proof electromagnetic directional valve, and its rated pressure overflow valve is adjusted. The pressure gauge observes the reading value on the pressure gauge. The downward movement of the hydraulic cylinder (i.e. lowering of heavy objects).Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.

Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods,NingxiaDongbo Fort, the operating failure rate can be reduced to a low level.Where can I find it?Setting requirements: When the distance between the outer edge of the construction electric elevator and the external overhead power line cannot meet the requirements of a small safety distance, the protective measures taken should comply with the specification requirements.Setting requirements: Buffers should be installed below the suspension cage and counterweight running channel.Construction electric elevators outside the lightning protection rangeNingxia,Mechanical devices controlled by cage movement should not be used to open or close the landing door.From the above comparison,NingxiaCharlotte, it can be seen that hydraulic electric lifting mechanisms have stable lifting, low noise, long service life, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.The pump body adopts an integrated pump station, which can also be selected according to customer requirements to meet customer ideal requirements.