VeronaDalasWhat to do if something goes wrong

It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations making high-altitude operations easierSpeed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.Verona,Construction electric elevators should be equipped with safety devices to prevent the cage from falling. The anti fall safety device should be functional at all times, including installation,VeronaTapolka, disassembly, and before resetting after action. Fall arrest safety gearUse floor doors and cage door devices on construction sites where conditions permit.Miami,It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations,VeronaCleveland, making high-altitude operations easierSpeed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.

Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.Precautions during operation: Mechanical operations should be gentle and smooth, and mechanical operations should be avoided, otherwise impact loads will inevitably occur, causing frequent mechanical failures and greatly shortening the service life. Generated during homeworkAfter the electric elevator passes the inspection, the user unit shall organize the leasing unit, installation unit, and supervision unit to conduct acceptance. For the implementation of construction general contracting, the acceptance shall be organized by the construction general contracting unit. The acceptance form should be signed by the relevant responsible person.Supply chain quality management,In addition to ground protective fences,VeronaStavavara, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between m and m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least mm above the ground.The verticality of the guide rail frame should meet the requirements of the specifications.When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.

Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.AdministrationThe function of the lifting platform in a theater is roughly as follows: the main lifting platform arranged in the main performance area of the stage is mainly used to quickly change the scenery. Typically, the lifting platform, and rear car turntable perform a rapid transformation of the entire or partial scene. This arrangement allows for rapid switching of three full sets.How to determine the sufficient amount of clean oil for the hydraulic station of an electric elevator? Why cannot water be used to flush the hydraulic station of an electric elevator?Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.Verona,Secondly, the lifting platform is driven by electrical energy and lifted by the hydraulic system. During operation, it is necessary to avoid irregular operations. To ensure the normal and orderly operation of the lifting platform and achieve the ideal unloading level, timely inspection of various functions is essential.Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, stable operation, accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table, it can be stopped arbitrarily within the range of travel.