Banzhuo WenBooster pipeline pumpHigh precision

because the length of the long shaft is generally fixed

　　The motor is scrapped. Moreover, the installation and use of the pump is troublesome, and the application occasions are subject to many restrictions.　　The two have certain commonalities. They are both submersible. As the name suggests, the pump is in an invasive state when running. The submersible slurry pump is a kind of submersible pump, but generally speaking, people often say that the submersible pump refers to the clean water pump, such as the submersible pump for domestic water and farmland irrigation and pumpingBanzhuo Wen,　　Starting mode. It can be widely used in industrial and agricultural production, water supply, drainage, fire control, sprinkler pipe network pressurization, HVAC cold and hot water circulation and other occasions.　　Pump, sewage submersible pump and seawater submersible pump.Comayagua,　　 selection of pump head: generally, the pump head shall be determined by enlarging the margin of % - %.　　Stop, then tighten the bearing seat, and fix the axial position of the rotor. The latter submersible slurry pump uses a barrel support, which generally does not need to adjust the impeller clearance. Therefore, if there is a problem with the clearance in the future use, loosen the support clamp first, and say that the nut is loose　　Promote the continuous expansion of the sales network group.

　　 the front and rear bearing glands are equipped with oil seals, which are padded with green paper or asbestos. There is a gap of .- mm between the rear gland and the bearing.　　For /g-g gravel pump, which belongs to large-diameter slurry pump, it is necessary to remove the impeller removal ring and rotate the impeller in the opposite direction.　　Submersible slurry pumps generally need to use some composite materials for manufacturing when they are used, so that they can have good wear and corrosion resistance when they are used, and can be used to transport most of the media when they are used. Phreatic slurryProcess inspection,Banzhuo WenVertical slurry pump,　　Water pump After understanding the cause of insufficient liquid supply, we can solve the problem: First, we need to check whether the liquid level of the circulating liquid storage tank needs to add media to it.　　Through the introduction, we learned that the submersible slurry pump can be used to transport slurry when it is used at ordinary times. The relationship between its special structure is very close, but in fact,Banzhuo WenSelf priming slurry pump wholesale, it also needs to be used in a correct way when it is used at ordinary times. Only in this way can　　 To ensure the efficient operation of the submerged slurry pump, the clearance between the impeller and the front guard plate must be adjusted regularly to keep it between (.-mm). In addition to monitoring the flow and pressure during the operation of the pump, the motor shall not exceed the rated current of the motor. Monitor oil seal and bearing at any time

　　 the water pipe shall be short, and the cavitation allowance of the device shall be greater than that of the pump. It is recommended to use the reverse charging installation method when transporting residues with high weight concentration.Promotion,　　 When stopping the operation of the submersible slurry pump close the cock of the vacuum gauge and pressure gauge and the gate valve on the water outlet pipeline, and After that cut off the power supply of the motor. If the temperature of the environment is low, open the square plug at the lower part of the pump body to remove the remaining water to avoid frost cracking. During operation, the maximum temperature of the bearing shall not exceed ℃, which can form a three-dimensional protection for the fire pump, including voltage overvoltage and undervoltage protection, current overcurrent and undercurrent protection, overload protection, phase loss protection, overheating protection, etc. this　　 The slurry pump mainly aims at conveying flow, so the flow meter (meter) shall be installed in the operation monitoring system as far as possible to monitor whether the flow meets the requirements at any time; In the pipeline system, slag flushing system and pressure filtration dehydration system equipped with hydrocyclone, certainBanzhuo Wen,　　 there is also a simple method to measure the vibration frequency of the pump by vibration method. However, when using one method, there may be some errors in the measurement results. When many equipment are used, there are other vibration sources that will affect the measurement results. Therefore, in fact, the medium slows down because the flow channel is also gradually expanding.