Santa CruzScrew deep well pumpPlease choose the correct way to use

　　Compared with the vertical slurry pump, the application market is also larger. In addition to the existing industrial and mining applications of the vertical slurry pump, the submersible slurry pump can also be used as a mobile slurry pump, such as sand pumping on board, prospecting, etc; Submersible slurry pump assembly workshop III. what are the advantages of submersible slurry pump　　Basically, the reasons for the motor heating of the submersible slurry pump are the above items. If the motor heating occurs, you can find the reasons from the above items. However, it must be noted that if the fault is caused by electricity, so as to avoid peopleSanta Cruz,　　There is a blockage in the water pump.　　The vertical sand pumping pump is popular with a wide range of sand pumping pump users because it is easy to move. This equipment is made of high-tech endurance data. Its service life has been greatly improved, and the maintenance frequency has been reduced, the cost has been reduced,Santa CruzVertical slurry pump, and the income has been increased.Hollola,　　The application of pumps involves all aspects of work and production, and the types of pumps are also diverse. Some of the same pump have several names, and some of the names are very similar, which makes it difficult to distinguish. Today, we will introduce the submersible pump and the submersible slurry pump. Is there any difference between the two　　 If there is abnormal sound inside the slurry pump and there is no water, it is likely that the equipment may have air infiltrating into it when absorbing water which will cause abnormal sound inside the pump, and then at the same time, the impeller is damaged or the impeller is damaged　　The hardened mud layer collapses after softening avoiding the phenomenon of burying the pump during use.

　　What?　　 The pump fails to supply water or the flow is insufficient. The pump fails to supply water or the flow is insufficient. It is likely that the suction pipe has water leakage or the bottom valve has air leakage, the stator winding will be burnt out due to excessive temperature rise.reform, so that it is convenient for us to disassemble the bearing parts; When the shaft is pulled out from the suction section, the fixing nut on the shaft shall be　　Water flow into the bearing damages the bearing.　　So it has a process of water diversion and exhaust. There are usually two ways to inject water into equipment. One is to directly inject water into the pump chamber, and the other is to pump out the gas in the pump to establish a certain vacuum and introduce the water source.

　　Under the action of auxiliary devices, it can transport the slurry, and because the sealing device itself is special, it can also ensure the internal and external balance of the submersible slurry pump during transportation, so that the pressure at both ends of the equipment can be balanced during normal useHow many?,　　The supply of shaft seal water must be ensured. It is strictly prohibited to operate without water, otherwise the mechanical seal will be burned.　　 The submersible sewage pump does not meet the standard power supply voltage required by the submersible sewage pump, so the user&#;s on-site power supply voltage may be too low, resulting in difficulty in starting the submersible pump. If the submersible pump can be started, the current of the submersible pump will be very large, and the motor of the submersible pump will be burnt out if the time is too long. In this case, please make sure　　The direction of the differential pressure force is opposite, which can offset part of the axial force and prolong the service life of the bearing.Santa Cruz,　　The use of water pumps for agricultural drainage and irrigation can improve the ability of agriculture to resist natural disasters increase production and ensure income, and provide material conditions for agricultural mechanization and water conservancy.　　 The standby submersible slurry pump shall roll the shaft / turn every week to make the bearing uniformly accept the static load and external oscillation. The building structure in the water pump room shall be reconstructed. Sound absorbing and isolating plates shall be installed around the wall and on the top of the machine room and fixed with light steel keel; The connecting holes between the machine room and other rooms are tightly blocked,Santa CruzCarbon steel explosion-proof pipeline pump,Santa CruzVortex pump and pipeline pump,　　 First of all, we need to choose equipment with formal certificates when making choices. We must avoid buying some obsolete or inferior products. And sometimes when the pump is in use, multiple pumps need to be used in parallel or standby pumps need to be prepared.