Las peziaFolding electric elevatorAnalysis of the operating specifications

The list of materials for making landing doors is as follows: Table : List of materials for making landing doors. Landing doors should be installed at the entrance of each landing station, and the landing doors should function properly.Work is essential,Las peziaElectric small elevator, and the main protective accessories include safety belts guardrails, protective covers, platforms and stairs, etc.Las pezia,Check whether the sealing of components such as the oil cylinder, oil pipe, and motor of the aluminum alloy electric elevator is good and whether there is any air leakage.The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.KoblenzPipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, it can automatically cut off the oil circuit and stop descentThe landing door should meet the requirements of the specifications and achieve standardization.The net height of the landing door opening should not be less than m, and the difference between the net width and the outlet width of the cage door should not exceed mm. When the floor door is closed, except for the gap between the lower part of the door that should not exceed mm, the size of any through-hole and opening related to the distance between any door and adjacent moving parts, as well as the gap around the door or between parts, should comply with the provisions of Table of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB-.

The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.Only after the operation of professional personnel can the suspension cage movement be restored.Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.A complete range of products,From the above comparison,Las peziaElectric elevator platform, low noise,Las peziaWarehouse electric elevator, long service life, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of meters by meters.

Setting requirements: The wall bracket should use the manufacturer's matching standard products.Sincere service, those that have undergone national safety certification will not have significant safety issues. The main problem is that after using the electric elevator for a period of time, mechanical components may fall off or be damaged due to various factors. This problem depends on regular inspection and maintenance of the machineryBefore installing the construction electric elevator, the foundation should be inspected and approved before installation.News Abstract: The development of the lifting platform industry will continue to grow in recent years! With the continuous development of electric lifting machinery for high-altitude operations in recent years, the products of electric lifting platform vehicles have been continuously improved, and various new technologies and materials have emerged, making the further development of lifting platform vehicles possible.Las pezia,When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.Civil engineering advantages: The pit depth of the guide rail type lifting platform is generally around -mm, and the top layer is not affected. It can be customized according to the location and environment.