Staya daroshiWater well pipeline pumpIt brings more than speed

　　Second, the service life of the flow passage parts of the pump is relatively long, saving production costs.　　Fourth, flow, dust, motor power, impeller speed, pumping rate, maximum particle and weight.Staya daroshi,　　 whether there is oil　　The mixing impeller and other main flow passage parts are made of high wear-resistant materials,Staya daroshiQuotation slurry pump, which are wear-resistant, corrosion-resistant, non clogging and have strong sewage discharge capacity, and can effectively pass through large solid particles. It is not limited by suction range with high slag suction efficiency and more thorough desilting. No auxiliary vacuum pump is required and the investment is lower. nothingUlan Bator,　　In fact, it can only be opened or closed, and the action time when opening and closing is relatively short.　　Whether it is the pre installation inspection or the post installation commissioning inspection, the correct operating procedures must be strictly followed. Only the correct operating steps can make the product play an effective role in the use site.　　We also need to limit the starting frequency and select appropriate thermal protection devices for use.

　　With water, you can start working.　　 Check the water pump: it is possible that the selection of the water pump is not matched with the motor, which makes the temperature of the motor too high after long-term operation; It is also possible that the working time exceeds the specified working time of the motor. At this time, the use time and times should be strictly limited, the correct thermal protection should be selected, and　　 selection of raw materials for flow passage parts: the raw materials for flow passage parts of the pump can be selected according to the particle composition, particle size, shape, hardness, concentration, acid, alkali and other characteristics of the transported materials.Manufacturing cost,　　; In practical application,Staya daroshiBaigang deep well pump, the submersible slurry pump is developing rapidly with its unique advantages. The vertical slurry pump needs to be fixed and installed in use,Staya daroshiDeep well pump, which is convenient and flexible.　　 Then tighten the compression nut on the packing gland evenly to make the liquid leak out in drops, complete protection s, reasonable structure convenient installation and high cost performance. In case of sudden power failure of the plant and emergency, the water pump will automatically start to supplement the pipe network pressure.

　　During adjustment, firstly loosen the support cover, then compress the nut, and then loosen the bearing seat. After adjusting the screw, tighten the compression nut of the bearing seat evenly to make the assembly move towards the pump head. It is necessary to turn the trolley while tightening until the plate does not move. Rotate according to the pump operationA complete range of products　　The direction of the differential pressure force is opposite, which can offset part of the axial force and prolong the service life of the bearing.　　What faults will the water pump control cabinet often encounter in use? The water pump cannot work: cause: a. the power supply is not connected or the output phase of the control cabinet is missing; b. The water pump has been burnt out, and the water pump can not supply water: cause: A. whether there is water in the pool; b. Whether there is gas in the pump body that is not discharged; c. Inlet and outlet water　　The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss.Staya daroshi,　　In addition, the sundries inside the pump body and impeller shall be cleaned. Then calibrate the pump shaft and motor shaft of the slurry pump to make them on the same horizontal line.　　So it has a process of water diversion and exhaust. There are usually two ways to inject water into equipment. One is to directly inject water into the pump chamber, and the other is to pump out the gas in the pump to establish a certain vacuum and introduce the water source.　　Water pump is a kind of machinery that pumps energy liquid. It is a machine that converts the mechanical energy of the prime mover into the potential energy of the pumped liquid. Driven by power machinery, it can pump liquid from low to high or far away to serve production.