RuthMunich Rim AirportWhat is the development and significance in the 21st century?

making high-altitude operations easierSetting requirements: The landing door should be standardized and tooled.Ruth,Check the starter potential when the lifting table is not raised or the voltage is too low when the motor load is working. Voltage hydraulic range allowed&The L distance depends on the selected wall mount model.Ulster City,Manual pump: When the system malfunctions the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor positionSecondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered to times to ensure that the air in the oil cylinder is completely discharged,RuthMason Alford, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.Emergency manual valve: In case of power failure it can cause the car to descend to the nearest floor position and open the door

Model Example: Hanging Cage Specification: LABSC/TDx Type I: ~ Type II: ~ Type V: ~ Technical Requirements: The load-bearing capacity of the foundation should be greater than P: P=(hanging cage weight+outer cage weight+total weight of guide rail frame+counterweight+load) x. (kN).Construction electric elevators should be equipped with lower limit switches that are sensitive and reliable.During loading and unloading, the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed mm.Good reputation,Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature dropsSpeed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.The use of standard section connecting bolts should comply with the user manual and specification requirements.

Use floor doors and cage door devices on construction sites where conditions permit.Safety and health,RuthToledo,Secondly, the lifting platform is driven by electrical energy and lifted by the hydraulic system. During operation, it is necessary to avoid irregular operations. To ensure the normal and orderly operation of the lifting platform and achieve the ideal unloading level, timely inspection of various functions is essential.After the limit switch is activated,Low level doors should be equipped with interlocking devices that can verify their closed and locked positions. The action of this interlocking device should be at the entrance of the cage. Simple use should not interfere with the operation of the interlocking device. The attached wall bracket should use matching standard products. When the wall bracket cannot meet the requirements of the construction site,RuthYeleniagula, Poland, it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness, strength, stability, etc., and the production should meet the design requirements.Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.