New WestminsterVertical centrifugal slurry pumpHow to balance the work

　　It should be /-/ between. When the packing is worn, the packing gland can be properly pressed. If it is worn too much it should be replaced. The whole commissioning process of the submersible slurry pump mainly includes the above five tasks, and timely deal with the problems in time to avoid being on duty Accidents during operation cause losses.　　First which are mainly to pay attention to the details and the phenomena occurred during the operation, let&#;s talk about the familiar vertical slurry pumps. Here we refer to ZJL and SP submerged slurry pumps. Strictly speaking, because its axis is basically vertical when it works, but it can be completely immersed in water when it runs, so it is a good choiceNew Westminster,　　 When the electric pump is not in use, take it out of the water and do not immerse it in the water for a long time, so as to reduce the chance of the motor stator winding getting damp and increase the service life of the electric pump. When the temperature is low, the pump needs to be lifted out to prevent freezing.　　 First of all, we need to choose equipment with formal certificates when making choices. We must avoid buying some obsolete or inferior products. And sometimes when the pump is in use, multiple pumps need to be used in parallel or standby pumps need to be prepared.Tiel,　　Most of the time, we don&#;t know how to choose the pump when we buy it. In fact,New WestminsterFire deep well pump, we only need to choose the appropriate equipment according to our own use needs when we choose it. It&#;s more like that in a conventional family, when we use it, the flow is small　　The above is the reason for the insufficient liquid supply of the water pump when it is in use, as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in use　　Commodity.

　　It is also necessary to clean the ventilation duct to avoid blockage.　　If there is a gap in the actual work, if the pipeline can not absorb water normally, it is necessary to find out whether the model of the pipeline pump can have the self-priming , and then check the cause of the abnormal suction range of the pipeline pump and solve it.　　 in addition, the noise method directly detects the noise of the equipment in the detection process, but such measurement will also be affected by the surrounding noise, so in fact, such measurement is not very accurate.Interpretation and observation,　　Different process requirements: the motor used in the vertical slurry pump is an ordinary vertical motor, which has no waterproof . The motor of the submersible slurry pump and the pump shaft are coaxial. The motor shall be waterproof and sealed. The motor and the pump body can invade underwater at the same time.　　 add water with manual pump. Some pump owners have their own hand pumps. They can also buy or manufacture their own small hand pumps. The gate valve shall be installed at the water inlet. After closing the valve, inject a small amount of water into the water compressor to divert water. When the hand pump discharges water, it means that the pump is full　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.

　　Rate.Information recommendation　　When the water level reaches, the frequency of the frequency converter drops, and the slurry pump operates at a low speed. The higher the water level, the lower the speed; The lower the water level, the higher the speed. At the same time, the circulation in the slag slurry pool is basically unchanged　　Stainless steel deep well pump is not a disposable product, nor a short-term product, but a long-term equipment. One investment can ensure long-term profits, and there is no need to replace equipment in a short time. Moreover, if there are some small problems, it is very easy to maintain, which are wear-resistant, corrosion-resistant,New WestminsterSubmersible sewage pump, non clogging and have strong sewage discharge capacity, and can effectively pass through large solid particles. It is not limited by suction range, with high slag suction efficiency and more thorough desilting. No auxiliary vacuum pump is required and the investment is lower. nothingNew Westminster,　　The two have certain commonalities. They are both submersible. As the name suggests, the pump is in an invasive state when running. The submersible slurry pump is a kind of submersible pump, but generally speaking, people often say that the submersible pump refers to the clean water pump,New WestminsterBooster pipeline pump, such as the submersible pump for domestic water and farmland irrigation and pumping　　 Then reinstall the equipment on the engine and install the rubber hose.　　Some impurities will entangle the impeller, so generally, the open impeller will be used, so there is no need to worry about getting stuck in the process of transporting sewage.